752940
8
Zoom out
Zoom in
Previous page
1/32
Next page
8
1
2
1. Disconnect and move freestanding
range from cabinet opening to provide
easier access to upper cabinet and rear
wall. Put a thick, protective covering over
cooktop, set-in range or countertop to
protect from damage or dirt.
2. Determine and clearly mark with a pencil
the center line of the cabinet on the wall
and on the underside of the cabinet where
the rangehood will be installed.
1. Remove the unit from the carton and
place on a at surface for assembly. Make
sure to cover the surface to
prevent accidental damage. Remove all
parts including the Backdraft Damper,
Screws, and Literature Package before
discarding the carton.
2. Remove both grease lters from the
unit and set aside. The rangehood is
shipped from the factory with the backdraft
damper attached inside. Using a Phillips
head screwdriver, remove the backdraft
damper by loosening the screw marked
with a red dot on top of the rangehood.
3. Before installing, the rangehood must
be adjusted for venting. For ductless
installations, read the following section
which discusses special requirements
for these installations before continuing.
Installation Instructions
8 1/2
"
1"
1
"
23
5/8"
- 29
7/8"
2"
3. The Agio attaches to the cabinet by four black screws. Mark the cabinet and insert
the screws (12f) into the underside of the cabinet as shown in gure. Do not tighten
the screws.
4. Determine the proper cutouts for the ductwork. Make all necessary cuts in the walls
or cabinets for the ductwork. Install the ductwork before mounting the rangehood.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber Agio 30PR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber Agio 30PR in the language / languages: English, French as an attachment in your email.

The manual is 7,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info