696240
14
Zoom out
Zoom in
Previous page
1/40
Next page
0
1
2
3
4
5
6
7
0 0,5 1 1,5 2 2,5 3 3,5
ENGLISH
cHecks and measures for commissioning
caution!
for correct generator operation, tHe Hydraulic system pressure must be between 0.6 and 2.5 bar.
Whenever the pressure detected by the digital pressure switch is lower than 0.6 or over 2.5 bar, the boiler goes into alarm mode.
By taking the pressure of the water within standard values, the alarm can be reset by pressing the
/1
key for 3 seconds
(The alarm can be reset only if the fumes motor has stopped and 15 minutes have passed since the alarm was displayed)
tHe pellet load motor does not function:
It is normal that there is air inside the circuit due to lling the system.
On the 1st ignition cycle, the movement of the water causes the air bubbles to move and be bled by the system automatic venting. This can
cause the pressure to drop and the minimum pressure switch to intervene, which interrupts operation of the pellet conveying motor and
therefore operation of the heat generator.
The system must be bled several times to eliminate the air and loaded when the pressure is too low.
It is not an anomaly, but normal phenomenon, due to lling. After lling, the system must always be bled using the relevant vents in the circuit
and having the machine perform the OUTLET AIR function. (After commissioning and with the machine cold, activate the OUTLET AIR
function again. - see "SETTINGS" chapter)
bulb tHermostats - rearm
Check by pressing rearm (95°C) , before contacting a technician (see REARM chapter).
The diagram at the side illustrates the behaviour of the
pump used on our thermo-products at the speeds that can
be set.
Flow rate (m
3
/h)
Head (m)
features
Water content of the thermo-product heat exchanger (l) 19
Volume of expansion vessel integrated into thermo-product (l) *8
3 bar safety valve integrated into the thermo-product YES
Minimum and maximum pressure switch integrated into the thermo-product YES
Pump integrated into the thermo-product YES
Pump max. head (m) 6
* ENVISION ANY INTEGRATIVE EXPANSION VESSEL ON THE BASIS OF THE SYSTEM WATER CONTENT.
14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame Virna Idro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame Virna Idro in the language / languages: English as an attachment in your email.

The manual is 3,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame Virna Idro

Extraflame Virna Idro User Manual - German - 40 pages

Extraflame Virna Idro User Manual - Dutch - 40 pages

Extraflame Virna Idro User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info