811782
20
Zoom out
Zoom in
Previous page
1/40
Next page
20 ENGLISH
J
NO IGNITION
THE APPLIANCE MAY FAIL TO LIGHT BECAUSE THE AUGER IS EMPTY AND NOT ALWAYS ABLE TO LOAD THE BURN
POT FAST ENOUGH WITH THE PELLETS NEEDED FOR NORMAL IGNITION. IF THE PROBLEM OCCURS AFTER ONLY A
FEW MONTHS OF OPERATION, CHECK THAT THE ROUTINE CLEANING DESCRIBED IN THE STOVE HANDBOOK HAS
BEEN CARRIED OUT CORRECTLY
OPERATION AND LOGIC
IGNITION
Once the previously listed points have been checked, press key 1 for three seconds to ignite the stove. During ignition, the stove will check
for a ame for a period of 15 minutes. Once the control temperature has been reached, the stove interrupts the ignition phase and switches
to PREPARATION.
The stove is set to MANUAL mode, power 5, by default.
PREPARATION
During the preparation phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and switch to WORK
WORK IN MANUAL MODE
During the work phase, the stove reaches the POWER dened by the user, heating the room using the VENTILATION set by the user.
ADJUSTMENT IN SET TEMPERATURE MODE
This mode, by means of the SET THERMOSTAT, allows for the room temperature to be set.
The adjustment is made using buttons 2 and 3, from 7 to 37°C.
If the value is between 7°C - 37°C, the stove checks the room temperature using a probe on the machine.
See paragraph MODE for more details.
AUX MODE
If AUX MODE is selected, temperature control is entrusted to the contact of the additional thermostat, thus ignoring the temperature probe
built into the radio control.
If the contact is open (met), the stove operates at the minimum value (or it switches o if STAND BY mode is active).
If the contact is closed (request), the stove works at the set power.
REGULATION OF SET POWER
Set Power has 5 levels of operation. The power can be changed with keys 2 or 3.
Power 1 = minimum level - Power 5 = maximum level.
Press key 1 to exit and save the change.
CLEANING
At preset intervals, the generator cleans the burn pot, turning the machine o.
When the cleaning phase is nished, the generator will re-start automatically and continue the working phase, returning to the power level
selected
AUTO BLOW
During the work phase, the stove cleans the burn pot at regular intervals with the function called "AUTO BLOW".
When this procedure starts, a message is displayed. During the "AUTO BLOW" procedure, the pellet feed slows down and the fumes motor
increases.
After cleaning, the stove resumes operation in normal conditions.
SWITCHOFF
Press key 1 for three seconds.
Once this operation has been performed, the appliance automatically enters the switch-o phase, blocking the pellet feed.
The ue gas exhaust motor and the hot air ow motor will remain on until the stove temperature has dropped below the safety settings.
REIGNITION
The stove can only be re-ignited if the temperature of the exhaust fumes is lower than the preset threshold and the minimum safety time has
passed.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame NORIS PLUS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame NORIS PLUS in the language / languages: English as an attachment in your email.

The manual is 14.29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame NORIS PLUS

Extraflame NORIS PLUS User Manual - German - 40 pages

Extraflame NORIS PLUS User Manual - Dutch - 40 pages

Extraflame NORIS PLUS User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info