696230
15
Zoom out
Zoom in
Previous page
1/32
Next page
ENGLISH
THE REMOTE CONTROL
All that can normally be implemented through the LCD can be adjusted using the remote control.
The table below provides a detailed description of the various functions:
1 ON / OFF Pressing the key for three seconds, the stove will switch on or o
2 POWER INCREASE Pressing the key will increase the operating power
3 POWER DECREASE Pressing the key will decrease the operating power
4 T° INCREASE The temperature setting can be increased by pressing this key
5 T° DECREASE The set temperature can be decreased by pressing this key
6
ENABLE / DISABLE
CHRONO
Pressing the key once will enable or disable the chrono
7
ENABLE DELAYED
SWITCHOFF
The delayed switch-o can be set by pressing this key.
For example, if the stove is set to switch-o in an hour, it shall switch-o
automatically once the set time elapses, displaying the countdown every
minute for delayed automatic shutdown.
8 MENU
This key allows the user to access the user and technical menu (the
technical menu is reserved for assistance)
9 INCREASE The temperature setting can be increased by pressing this key
10 ESC KEY
The key allows the user to exit any program or display and returns to the
main menu without saving the data
11 BACK The key returns to the display of the various menus
12 CONFIRMATION KEY
This key conrms the adjustments made during the user menu
programming phase
13 FORWARD The key allows the user to go forward in the various menus
14 ENABLE FUNCTION F1 Pre-set key for future applications
15 DECREASE The key decreases the value to be set
16 STOVE STATUS Pressing this key will display the general status of the stove
TYPE AND REPLACEMENT OF BATTERIES
The batteries are housed in the lower part of the remote control.
To replace it, you need to take out the battery holder, remove or insert the battery following the symbols on the remote control and on the
battery.
For operation, 1 CR2025, 3V lithium buer battery is required.
The batteries used contain metals harmful for the environment. They must therefore be disposed of separately in appropriate containers.
Important note: the numbers shown on the remote control are purely indicative and are not present on the remote control supplied with the product.
IF THE REMOTE CONTROL IS OFF BECAUSE IT HAS NO BATTERIES, THE STOVE CAN BE CONTROLLED FROM THE CONTROL
PANEL ON TOP OF IT. WHILE REPLACING THE BATTERY, PAY ATTENTION TO THE POLARITY BY OBSERVING THE SYMBOL ON
THE INSIDE COMPARTMENT OF THE REMOTE CONTROL.
J
ALL CLEAN CHECK UP
SHOULD THE "ALL CLEAN CHECK UP" ALARM BE TRIGGERED, MAKE SURE
THAT THE BOTTOM OF THE BURN POT IS FREE OF RESIDUES OR SCALES.
THE HOLES AT THE BOTTOM MUST BE COMPLETELY FREE TO GUARANTEE
CORRECT COMBUSTION. ONE CAN USE THE FUNCTION TO ADJUST
COMBUSTION BASED ON THE DESCRIBED REQUIREMENTS. IF THE ALARM
PERSISTS AND THE ABOVE LISTED CONDITIONS HAVE BEEN CHECKED,
CONTACT THE QUALIFIED AFTERSALES ASSISTANCE CENTRE.
BURN POT BOTTOM
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame Melinda idro 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame Melinda idro 2.0 in the language / languages: English as an attachment in your email.

The manual is 5,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame Melinda idro 2.0

Extraflame Melinda idro 2.0 User Manual - German - 32 pages

Extraflame Melinda idro 2.0 User Manual - Dutch - 32 pages

Extraflame Melinda idro 2.0 User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info