695853
19
Zoom out
Zoom in
Previous page
1/36
Next page
19ENGLISH
OPERATION AND LOGIC
NEVER USE FLAMMABLE LIQUIDS FOR IGNITION!
WHILE FILLING, DO NOT BRING THE PELLET BAG IN CONTACT WITH THE BOILING STOVE!
IN CASE OF CONTINUOUS FAILED IGNITIONS, CONTACT AN AUTHORISED TECHNICIAN.
DO NOT USE THE APPLIANCE WITHOUT THE SEPARATOR AND/OR FLAME
GUARD SEE FIGURE TO THE SIDE. REMOVING THEM WILL AFFECT THE SAFETY
OF THE PRODUCT AND WILL INVALIDATE THE WARRANTY IMMEDIATELY. IN
THE EVENT OF WEAR OR DETERIORATION, REQUEST THE REPLACEMENT OF
THE PART FROM THE SERVICE CENTRE THIS TYPE OF REPLACEMENT IS NOT
COVERED BY WARRANTY BECAUSE IT IS A COMPONENT SUBJECT TO WEAR.
SEPARATOR
IGNITION
After checking the previous points, press the 1 for three seconds to switch on the stove. For the ignition phase, 15 minutes are available during
which the presence of the ame is checked. When the control temperature has been reached, the stove stops the ignition phase and goes into
PREPARATION.
PREPARATION
During the preparation phase, the stove stabilises and gradually increases combustion, and then activates the ventilation and goes into WORK
WORK
During the work phase, the stove reaches the Set Power dened by the user, heating the room until the Set Thermostat has been reached. See
following note.
SET THERMOSTAT
The Set room thermostat can be set using keys 4 and 5, from LOWTA - 7°C - 37°C - HOT. If the value is between 7°C - 37°C, the stove checks
the room temperature using a probe on the machine. Once the set temperature has been reached, the stove automatically reduces the power
ensuring optimal comfort and reducing the consumption of pellets: this process is called "modulation".
LOWTA / HOT
If the Set Thermostat is "LOWTA" (set below the 7° threshold) the temperature is checked by the additional thermostat contact, thus ignoring
the temperature probe on the machine.
If the contact is open (met), the stove operates at the minimum value.
If the contact is closed (required), the stove operates at the set power.
If the setting is on HOT (set above 37°C) the stove always operates at the set power, ignoring the external contact and the temperature probe.
SET POWER
The Set Power ha 5 levels of operation. The power can be changed using keys 2 or 3.
Power 1 = minimum level - Power 5 = maximum level.
The change is saved after exiting by pressing 1.
BLOW
During the work phase and at regular time intervals, the stove cleans the burn pot by means of an operation called "BLOW".
The activation of this function is shown on the display with the relative message. During the "BLOW" the pellet loading is slowed down and
the fumes motor is increased.
After the cleaning phase, the stove goes back to the normal operating conditions.
SWITCHOFF
Press 1 for three seconds.
After performing this operation, the appliance automatically enters the switch-o phase, and stops loading pellets.
The fumes motor and the hot air fan motor remain on until the stove temperature falls below the safety threshold.
REIGNITION
The stove can be switched back on only if the fume temperature is lower than a preset threshold and if a minimum safety time has elapsed.
FLAME GUARD
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame Lucia at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame Lucia in the language / languages: English as an attachment in your email.

The manual is 5,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame Lucia

Extraflame Lucia User Manual - German - 36 pages

Extraflame Lucia User Manual - Dutch - 36 pages

Extraflame Lucia User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info