811756

Extraflame Isidora Idro H16 Manual

23
Zoom out
Zoom in
Previous page
1/40
Next page
23ENGLISH
OPERATION AND LOGIC
IGNITION
Once the points listed previously have been checked, press key 1 for three seconds to ignite the stove. 15 minutes are available for the ignition
phase. After ignition and having reached the control temperature, the stove interrupts the ignition phase and passes to STARTING.
PREPARATION
During the start-up phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and pass on to WORK.
WORK
During the work phase, the stove reaches the set power set; see following item.
SET POWER
Set the operating power from 1 to 5 (using keys 2 and 3).
Power 1 = minimum level - Power 5 = maximum level.
SET H2O
Set the boiler temperature from 65 to 80°C (using keys 4 and 5).
PUMP OPERATION
The pump is activated when the internal water temperature reaches 60°C. Since the pump is always in operation above 60°C, it is advisable
to keep a heating area always open so that the product operates in a more homogeneous manner and in order to prevent stoppages due to
overtemperature. This area is usually called “safety area”
CLEANING
At preset intervals, the generator cleans the burn pot, turning the machine o.
When the cleaning phase is nished, the generator will re-start automatically and continue the working phase, returning to the selected
power level.
BLOW
During the working phase, the stove has an internal timer, which after a pre-set period of time cleans the burn pot.
This phase is shown on the display, it lowers the stove power level and increases the ue gas exhaust motor for a programmed period of time.
When the cleaning phase is nished, the stove will re-start automatically and continue the working phase, returning to the selected power
level.
MODULATION and HOFF
As the water temperature approaches the set point, the boiler starts to modulate automatically bringing itself to the minimum power. If the
temperature increases beyond the set point, it will automatically switch o indicating HOFF, and will automatically go back on when the
temperature drops below the set point.
SWITCHOFF
Press key 1 for three seconds.
Once this operation has been performed, the appliance automatically enters the switch-o phase, blocking the supply of pellets.
The ue gas exhaust motor and the hot air ow motor will remain on until the stove temperature has dropped below the default
parameters.
REIGNITION
The stove can only be re-ignited automatically or manually when the cooling cycle conditions and the preset timer have been satised.
IT IS PROHIBITED TO USE THE APPLIANCE WITHOUT THE PARTITION AND/
OR FLAME GUARD SEE FIGURE ON SIDE. REMOVAL WILL COMPROMISE THE
SAFETY OF THE PRODUCT AND RESULT IN THE IMMEDIATE NULLIFICATION OF
THE WARRANTY PERIOD. IN THE CASE OF WEAR OR DETERIORATION, REQUEST
AFTERSALES ASSISTANCE TO REPLACE THE PART REPLACEMENT IS NOT
COVERED BY THE WARRANTY AS THE COMPONENT IS SUBJECT TO WEAR.
PARTITION
FLAME GUARD
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame Isidora Idro H16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame Isidora Idro H16 in the language / languages: English as an attachment in your email.

The manual is 7.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame Isidora Idro H16

Extraflame Isidora Idro H16 User Manual - German - 40 pages

Extraflame Isidora Idro H16 User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info