811700
25
Zoom out
Zoom in
Previous page
1/36
Next page
ENGLISH
DELTA T
This function allows the hysteresis limit to be set for stove switch-on and switch-o DELTA T, used as
an interval of regulation in the event the room temperature is not managed by an external thermostat.
The exact switch-on temperature is SET THERMOSTAT  DELTA T. The switch-o temperature is SET
THERMOSTAT + DELTAT.
Possible DELTAT values range from: 0.5 - 5°C
To set: OK > SETTINGS > DELTAT
RESET
Allows the user to restore all editable values to the default values.
To set: OK > SETTINGS > RESET.
INSTALLATION MUST BE PERFORMED BY QUALIFIED STAFF AND/OR THE MANUFACTURER'S AFTERSALES
TECHNICIANS.
ADDITIONAL FUNCTIONS
FIRST LOAD
This function enables the pellet loading gear motor for continuous functioning.
Before enabling this function, make sure the stove is cold and in “OFF mode. Press buttons 6 + 4 at
the same time for a few seconds until "FIRST LOAD appears on the screen.
To interrupt continuous loading, simply hold key 6 down for 2 seconds.
COMFORT FUNCTION
In specic models, this function reduces the ventilation speed, thus minimising the noise levels of
the stove.
To enable, hold keys 6 + 3 pressed for 2 seconds until COMFORT ON is displayed on the
screen.
To disable, hold keys 6 + 3 pressed for 2 seconds until COMFORT OFF is displayed on the
screen.
Comfort enabled Comfort disabled
INSTALLATION OF SUPPLEMENTARY THERMOSTAT OPTIONAL
The appliance is able to control the room temperature through a supplementary thermostat (optional).
After the stove is switched on (by pressing 1 or in chrono mode), it will work to reach the set thermostat temperature, displaying WORK
(open contact) on the screen. The room sensor supplied standard will automatically be ignored.
When the thermostat reaches the temperature (closed contact) the stove will work at the minimum power level, displaying MODULATION
ON THE SCREEN.
CONTROLS PROCEDURE
A mechanical or digital thermostat is needed with a “normally open input type.
Remove the plug from the socket.
Using the image to the side as a guide, connect the two thermostat wires (clean contact - no
220 V!) to the respective terminals at the back of the machine, one red and the other black.
Connect the power to the stove again.
Press key 3 until SET THERMOSTAT is set to LOWTA.
25
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame Angela Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame Angela Plus in the language / languages: English as an attachment in your email.

The manual is 4.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame Angela Plus

Extraflame Angela Plus User Manual - German - 36 pages

Extraflame Angela Plus User Manual - Dutch - 36 pages

Extraflame Angela Plus User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info