811656
22
Zoom out
Zoom in
Previous page
1/40
Next page
22 ENGLISH
IGNITION
Once the previously listed points have been checked, press key
for three seconds to ignite the stove. During ignition, the stove will check
for a ame for a period of 15 minutes. Once the control temperature has been reached, the
stove interrupts the ignition phase and switches to PREPARATION.
PREPARATION
During the preparation phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and switch to WORK
WORK
In the work phase, the stove switches to the SET POWER dened by the user, heating the room until SET THERMOSTAT is achieved. See next
heading.
ADJUSTING SET THERMOSTAT
The SET room thermostat can be set using keys 2 and 3, from LOW-TA - 7°C - 37°C - HOT. If the value is between 07°C - 37°C, the stove checks
the room temperature using a probe in the handheld control. Once the set temperature has been reached, the stove automatically reduces
the power, guaranteeing best comfort and reducing pellet consumption: this process is called modulation.
LOWTAHOT
If the SET THERMOSTAT is “LOWTA (set under the 7°C threshold), the temperature is checked by the additional thermostat contact, thus
bypassing the temperature probe in the handheld device.
If the contact is open (fullled), the stove works at minimum power.
If the contact is closed (request), the stove works at the set power.
If the setting is on HOT (set above 37°C), the stove only works at the set power, thus bypassing the external contact and the temperature
probe.
ADJUSTING SET POWER
The set power has 5 levels of operation, Pressing the key
OK
allows you to view the set power which can be changed using the keys
OK
or
OK
.
Power 1 = minimum level - Power 5 = maximum level.
The change must be conrmed by pressing the key
OK
.
AUTO BLOW
During the work phase, the stove cleans the burn pot at regular intervals with an "AUTO BLOW".
When this procedure starts, a message is displayed. During the "AUTO BLOW" procedure, the pellet feed slows down and the fumes motor
increases.
After cleaning, the stove resumes operation in normal conditions.
SWITCHOFF
Press the
OK
key for three seconds.
Once this operation has been performed, the appliance automatically enters the switch-o phase, blocking the supply of pellets.
The ue gas exhaust motor and the hot air ow motor will remain on until the stove temperature has dropped below the safety settings.
REIGNITION
The stove can only be re-ignited if the temperature of the exhaust fumes is lower than the preset threshold and the minimum safety time has
passed.
OPERATION AND LOGIC
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Extraflame ANGELA EVO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Extraflame ANGELA EVO in the language / languages: English as an attachment in your email.

The manual is 7.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Extraflame ANGELA EVO

Extraflame ANGELA EVO User Manual - German - 40 pages

Extraflame ANGELA EVO User Manual - Dutch - 40 pages

Extraflame ANGELA EVO User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info