12
Assembly page 12/28
INITIAL OPERATION
When you use your appliance for the first time, pour fresh water into the water tank and switch
on the appliance (without coffee).
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough, repeat the process with fresh water. Repeat this process twice.
SETTING THE CLOCK
Plug in your coffee maker. The time "12:00" will be displayed on the electronic digital clock.
Then press the HOUR button to set the hours, and the MINUTE button to change the
minutes.
By each impulse on one of those buttons, the hour or minutes will increase by 1 unit but if
you keep the pressure, the time will roll forward more quickly.
PREPARATION OF COFFEE
Open the lid of the water tank.
Using the thermos jug, pour the desired amount of water into the water tank. Make sure
not to overfill by respecting the maximum level indicated on the water tank.
Place the filter holder into the coffee maker. Put a filter in the filter holder and add the
desired quantity of ground coffee in the filter. Put back the filter holder, making sure it is
placed correctly.
Never forget to close the lid of the water tank and to place the thermos jug on the
warming plate before switching on your coffee maker.
If you want to adjust the coffee strength, you can press the “STRENGTH” button once, and
then the STRENGTH indicator will illuminate in orange and the appliance will brew thick
coffee. If you do not want strong coffee, just follow the following operation to brew
normal coffee.
Press the on-off switch to switch on the coffee maker. The pilot light will be illuminated in
red, indicating that your appliance is working. A device allows you to keep coffee warm
for as long as the coffee maker is working and the jug is standing on the appliance.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
You can switch off your appliance anytime simply by pressing the on-off switch (the pilot
light will be off). The appliance will continue brewing once the ON/OFF button is pressed
again.
Your coffee maker will switch off automatically 60 minutes after it has stopped brewing
coffee.
PROGRAMMING THE COFFEE MAKER
To programme your coffee maker to brew fresh coffee at a preset time, first follow steps 1 to 5
in the “PREPARATION OF COFFEE” section.
Make sure the coffee maker’s clock is set to the right time.
Press the PROGRAM button once. The clock will now display 12:00 and the ON/OFF indicator
flashes in green. Use the HOUR and MINUTE buttons to set the desired brew time. Once the
setting is finished, press the DELAY BREW button. The programming time will disappear and will
be replaced by the clock time. The ON/OFF pilot light will be illuminated in green.
