Manual Exquisit GTE 215 (page 13 of 37) (English, German, Dutch, French)

564678

Zoom out

Zoom in

1/37

English Instruction for use CHEST FREEZERS

Directions for use

In the following, you will find all the important information

for the use of your appliance.

The instructions for use apply to several models, which is

why details of the information may differ according to the

type of the appliance.

1 Installation (Choice of position for installation)

Strictly avoid high ambient temperatures and direct

sunlight. We advise you to place your appliance in a cool,

well aired, dry room. Installation in the immediate vicinity of

a heat source (heating, oven etc.) is highly inappropriate

(increased compressor performance

would be necessary

and, as a result, energy consumption would be considerably

higher).

If the installation near a heat source cannot be avoided, a

suitable insulation plate must be fitted between the

appliance and the heat source (do not use asbestos), or

the following minimum distances must be observed:

Omit any mechanical influence on the cooling system,

especially on the condenser as far as available.

With some appliances the condenser is built into the

external wall.

Interventions on the cooling system must be carried out by

professional and authorised personnel only.

IMPORTANT!

Escaping refrigerant can injure

your eyes.

In the event of eye contact with the refrigerant, wash your

eyes instantly under plenty of running water and

call/consult an eye specialist immediately.

CLIMATE CLASSES

The appliance, according to its climate category, is meant

for use at certain room temperatures.

These temperatures should not be exceeded! The climate

category for your particular appliance is marked on the

rating plate. The categories are:

name of climate suitable

• from gas or electric cooker

• from radiator or oven

• from a wall, piece of furniture or

another appliance

Never obstruct the ventilation grid

3 cm

5 cm

2 cm

category

room temperatures

+ 10° C to + 32°C

+ 16° C to + 32°C

+ 18° C to + 38° C

+ 18° C to + 43° C

Larger chest freezers are equipped with a ventilation grille

(k) located below on one side. These appliances can be

placed directly against a wall or a piece of furniture but not

with the side protected with the ventilation grille.

Freezers without ventilation grid

Leave sufficient space between the rear of the appliance

and the wall to ensure that outward flow of warm air is able

to escape.

The appliance must be placed horizontally and on a

levelled base. Only this way can an impeded circuit of the

refrigerant

and optimum function be ensured.

IMPORTANT!

Leave the appliance stand in the final position for at

least 2 hours before switching it on, so that the

refrigerant circuit stabilises and no operating problems

occur.

The odour which is typical of all new appliances is easy to

remove.

Thoroughly clean the interior compartment with a mixture of

lukewarm water and vinegar.

Do not use washing liquids, sharp or granular cleaning

implements, or any cleaning products containing soda.

Before connecting the appliance, make sure that the inner

area – especially the corners – is absolutely dry.

Danger warning

Dep

ending on its composition, the refrigerant is easily

inflammable. The refrigerant circuit is hermetically sealed

and the density has been subject to repeated tests.

An improper intervention can cause acute fire hazard.

2 Rating plate

The rating plate (with technical data) is located on the

housing (D) at the rear of the appliance.

Take a note of the technical data

Copy the technical data from the rating plate to here so that

it is at any time readily available, without having to move

the appliance

Model/Type …………….…………………………

Gross capacity ……………………………….litres

Net capacity ………………….……………litres

Operating voltage ………………….……...…...V-50Hz

Maximum absorbed power(W)..……………….Watt

Safety (A) ……………….....………………..

....Amp

Energy consumption…………………………....kWh/24h

Freezing capacity …………………………….....kg/24h

3 Connection to power supply

Your appliance must be connected to a power socked with

grounded connection, which is conform to the respective

standards and has been installed by an authorised

specialist.

Before you connect the plug of the appliance with the

power socket, make absolutely sure that

the voltage (V) on the appliance’s data-plate corresponds

with that of your mains.

If the voltage differs, notify the after-sales-service or your

dealer immediately, and do not on any account connect the

appliance to the mains.

4 Switching on / off temperature selection

(Thermostat) (l)

The temperature control switches the appliance on and off

and controls/set

s the cooling temperature.

To prevent temperature being accidentally modified, the

control is intentionally resistant to turning. To vary the

setting, we recommend to use a coin or screwdriver.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Exquisit GTE 215 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Exquisit GTE 215 Manual

Product: