564707

Exquisit F 245 Manual

7
Zoom out
Zoom in
Previous page
1/37
Next page
7
GB
● ATTENTION! The appliance must not touch any pipes for heating, gas or water supply, or any
other electrical devices.
● Do not cover the ventilation holes at the top of the appliances– it must be a good air circulation
around the appliance. There should be a gap of at least 10 cm between the top of the appliance body
and any furniture that may be above it (fig. 5, see page 3). If this requirement is not followed, the
appliance consumes more electrical energy and its compressor may overheat.
● If the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance body
and the wall so that the freezer compartment door can be opened enough to pull out the frozen product
drawer (fig. 6, see page 3).
● The appliance must stand on a level surface and must not touch the wall. If necessary, regulate
the height of the appliance by adjusting the levelling feet: by turning them clockwise – the front of the
appliance rises, by turning them counter clockwise – it comes down. If the appliance is tilted slightly
backward – the doors will close by themselves.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a helper. You
will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
! When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally.
Do the actions below in the order they are listed (fig. 7, see page 3):
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
1. Remove the bottom cover 10.
2. Unscrew two screws 7 and remove the bottom bracket 8 together with the washers 6 on the
axle and the spacer 5.
3. Remove the door 4. Unscrew the axle 2 together with the nut 1 and the washers 3 from the
upper bracket and screw all this set on the left side of the door.
4. Displace the plug 14 on the right side, hang the door on the axle 2.
5. Prior to unscrewing the bracket 11 and counterchanging it with the bottom bracket 8 (together with
the set of washers and spacers), insert the bracket axle into the door.
6. The brackets 9 which are under the brackets 11 and 8 remain in their places;
7. Put on the bottom cover 10.
REVIEW OF MECHANICAL CONTROL
CONTROL PANEL — DESCRIPTION OF SYMBOLS AND OPERATIONS
Fig. 1, see page 2
1 – THERMOSTAT POSITION INDICATOR, marked with the symbol
The thermostat position is seen on the thermostat position indicator.
2 - THERMOSTAT KNOB. The temperature in the appliance is controlled using the thermostat knob.
The thermostat is off when there is a zero (0) in the thermostat indicator space. Turning the
thermostat knob clockwise lowers thetemperature in the compartment.
3 - FAST-FREEZE INDICATOR, marked with the symbol
When the fast-freeze mode is turned on, the yellow indicator light is illuminated. Instructions on
how to use the fast-freeze function are in the section entitled "Freezing of food stuffs in the freezer
compartment".
ATTENTION! The fast-freeze function does not turn off automatically — it needs to be
switched off!
ATTENTION! When the fast-freeze mode is on, the appliance's compressor works non-stop.
4 - THE TEMPERATURE RISE INDICATOR is marked with the symbol
When the temperature in the freezer compartment rises above -14 ºC, the red indicator light is
illuminated. It indicates that:
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Exquisit F 245 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Exquisit F 245 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info