717723
12
Zoom out
Zoom in
Previous page
1/36
Next page
11
the wall. Pull the appliance away from any furniture or walls. Check that the cause of increased
noise isn’t due to bottles, cans or dishes in the appliance that might be touching each other.
Water has appeared at the bottom of the refrigerator compartment. Check whether a
thaw water channel space isn’t blocked. Clean the thaw water channel space with a cleaner
intended for that purpose.
Water has appeared under the appliance. The thaw water collection tray has slipped off
the compressor. Place the tray on top of the compressor.
When the appliance door is opened, the rubber sealing gasket pulls out. The gasket is
smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the groove for it with
warm water containing soap or dishwashing detergent and wipe dry. Put the rubber sealing
gasket back into the place.
High temperature in appliance, the compressor operation pauses are short. Ascertain
whether the appliance door/doors are shutting tightly, whether the door wasn’t kept open longer
than necessary when taking out or putting in foodstuffs or whether a large amount of warm
food was placed in the appliance.
The top of the appliance has condensation on it. The ambient relative air humidity is
above 60 %. Ventilate the room where the appliance stands and if possible remove the cause
of the humidity.
TRANSPORT
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE APPLIANCE
THAT RESULTS FROM NON-COMPLIANCE WITH THE INSTRUCTIONS FOR
TRANSPORTATION.
The appliance should be transported only in the vertical position.
When being transported, the appliance should be protected from atmospheric conditions (rain,
snow, dampness).
The appliance should be firmly secured in place while being transported, to avoid slippage or any
shocks in the transport vehicle.
If the appliance was transported not vertically, it may be connected to the mains after 4 hours at
least. If this is not done, the appliance compressor may fail.
ENVIRONMENTAL PROTECTION INFORMATION
This symbol indicates that once the appliance is no longer needed, it cannot be disposed
together with other miscellaneous municipal waste. It should be collected and eliminated
separately, i.e. in containers specially marked with this symbol in large-dimension rubbish
collection areas. Full information on where to submit the old appliance safety can be
obtained from local government authorities, the shop where you bought the appliance or the
manufacturer’s representatives.
If you decided to scrap the appliance, make it impossible to use in order to prevent possible
misadventure. Pull out the electric plug from the electricity supply socket and then cut off the cord.
Tear off the gasket. Break the door lock if any.
WARNING! Do not dismantle the appliance yourself. Pass it on to recycling
companies.
WARRANTY SERVICE
IF YOUR APPLIANCE IS NOT WORKING PROPERLY,
ASCERTAIN WHETHER YOU CAN REMEDY THE CAUSE OF
THE FAULTY FUNCTIONING OF THE APPLIANCE
YOURSELF. If you cannot solve the problem yourself,
contact the nearest refrigerator service representative by
telephone or in writing. When making contact necessarily
indicate the refrigerator model 1 and number 2. You will
find this data on the product label, which is glued to the wall.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Exquisit CD350-2D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Exquisit CD350-2D in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info