801966
10
Zoom out
Zoom in
Previous page
1/18
Next page
~ 9 ~
Overall user manual
© 2011 VAN OS MEDICAL UK LTD.
Tel. +44(0)1757 701177, Fax +44(0)1757 706011, E-mail: sales@vanosmedical.com, www.vanosmedical.com
6.3.1 Diagnosing Faults
Use the following troubleshooting guide if the scooter fails to operate.
Note:
Turn the key switch on before beginning any diagnostics.
If the Status Light is OFF
Check that the key switch is turned ON
Check that all cables are connected correctly
If only the leftmost diode of the battery charge display is PERMANENTLY ON
Contact your authorised Excel® Dealer
If the leftmost diode of the battery charge display is FLASHING
Count the number of flashes and refer to the next section.
6.3.2 Flash Codes
Number
of
flashes
Impact on Scooter
Notes
1
Will Drive
Battery charge is running low. Recharge the batteries as soon
as possible.
2
Drive inhibited
Battery charge is empty. Recharge the batteries.
If the scooter is left off for a few minutes, battery charge may
recover sufficiently to allow driving for a short period of time.
Driving speed
reduced
Lower lifter completely.
3
Drive inhibited
Battery charge is too high. If a charger is plugged in, unplug it.
The electronic system charges the batteries when travelling
down slopes or decelerating. Excessive charging in this manner
may cause this fault. Turn the scooter power off and then back
on again.
4
Drive inhibited
The scooter has drawn too much current for too long, possibly
because the motor has been over-worked, jammed or stalled.
Turn the scooter power off, leave it off for a few minutes, and
then turn the power back on again.
The controller has detected a short-circuited motor. Check the
cable harness for short and check the motor: Contact your
authorised Excel® Dealer. Check that the declutching lever is
in the engaged position.
5
Drive inhibited
The park brake coil or wiring is faulty. Check the park brake
and wiring for open or short circuits. Contact your authorised
Excel® Dealer.
6
Drive inhibited
Throttle is not in neutral position when turning key switch on.
Return throttle to neutral, turn power off, and back on
again.
Throttle may need to be re-calibrated. Contact your authorised
Excel® Dealer.
7
Drive inhibited
The throttle or its wiring may be faulty or incorrectly set up.
Contact your authorised Excel® Dealer.
8
Drive inhibited
The motor or its wiring is faulty. Contact your authorised
Excel® Dealer.
9
Drive inhibited
Contact your authorised Excel® Dealer.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Excel Entice Universe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Excel Entice Universe in the language / languages: English as an attachment in your email.

The manual is 1.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info