2. Fill the water
When the mobile air conditioner gives the signal to fill water (no water in the water reservoir during
the first use or water shortage during use), follow the steps below to fill the mobile air conditioner with
water:
1. Use the water filler connection on the back of the air conditioner to connect the filling
hose to the tap . Press the water supply button ('Water Inlet ') and open the filling tap , this
should be done simultaneously.
2. When the water level reaches the correct height, the water inlet valve will close
automatically to stop the water supply .
3. Remove the hose and screw the lid of the filler neck fixed.
3. Cooling
1. Press 【mode】in order to select the cooling mode.
2. Press【+】or 【-】in order to set the desired temperature. Set the temperature in
between the first 6 and 32 ℃ ℃.
3. Press【wind speed】in order to set the desired speed. There are three positions: low,
high or automatic .
4. Press【swing wind】to set the discharge blades in the correct position. The slats can
move up and down automatically in the swing position and can be locked in the desired position.
Pay attention:
The actual air inlet temperature is displayed during cooling.
When the cooling capacity of the water in the water tank is used up (water temperature is 50 ° C), the
air conditioning automatically stops cooling. The water must then cool down to be able to cool again.
It is also possible to use the ' cold storage' function to cool the water. It is also possible to replace the
water in the air conditioning for cold water in order to be able to switch back to cooling mode.
4. Strong cooling ('Strong Cooling ')
This mode can be used when fast cooling is required.
1. Press【mode 】to select the forced cooling function .
