814565

Everglades EVCO1021 Manual

56
Zoom out
Zoom in
Previous page
1/78
Next page
PROBLEM POSSIBLE CAUSE(S) SOLUTION
Troubleshooting
WARNING
Before trouble shooting, disconnect the power
supply. Only a qualified electrician of
competent person must carry out the trouble
shooting that is not in the manual.
Important!
Repairs to refrigerators/freezers may only be
performed by competent service engineers.
Improper repairs can give rise to significant
hazards for the user. If your appliance needs
repairing, please contact your specialist
dealer or your local Service Center.
Appliance does
not work.
Appliance is not switched on.
Mains plug is not plugged
in or is loose.
Fuse has blown or is defective.
Socket is defective.
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected
by an electrician.
Appliance cools too
much. Temperature is set too cold. Turn the temperature regulator to a warmer
setting temporarily.
The food is too
warm.
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the “Installing your
new appliance” section.
Please refer to the “Control panel” section.
Interior LED Light does
not work. LED Light is defective. Please look in the “cleaning and care”
section.
Heavy build-up of
frost, possibly also on
the door seal.
Door seal is not air-tight
(possibly after reversing the
door).
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool setting).
At the same time shape the warmed door
seal by hand such that it sits correctly.
Unusual noises.
Appliance is not level.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Readjust the feet.
If necessary, carefully bend the component
out of the way.
The appliance is touching the
wall or other objects. Move the appliance slightly.
The compressor does
not start immediately
after changing the
temperature setting.
This is normal, no error has
occurred.
The compressor starts after a period of time.
Water on the floor or
storage shelves. Water drain hole is blocked. See the “cleaning and care” section.
18
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Everglades EVCO1021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Everglades EVCO1021 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5.1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info