668822
34
Zoom out
Zoom in
Previous page
1/47
Next page
04. PRODUCT USE
33
User functions
Standard functioning of a control board properly installed on a forced air pellet stove is described below with reference to the
functions available to users. The indications listed below refer to a control board fitted with programmable thermostat.
Before switching on the stove, the display is as in figure 16.
fig. 16
Stove ignition
Make sure that there are pellets in the hopper, that the burn pot is correctly positioned and clean from any combustion residues and
then close the door.
Hold down P4 for a few seconds to switch on the stove. The display shows that the stove is on.
Start-up phase
The stove performs all the steps of the start-up phase according to the parameters concerning its levels and times. The display will
show the wording ON, as there is no pellet loading but the fume fan is operating. PELLET LOADING state will occur where the pellets
are being loaded into the burn pot. Once the pellets have started to burn and the fume temperature is increased, the display will show
FIRE ON, a transition phase between ignition and operating power.
Ignition failure
The alarm is triggered when, after the period of time set by Pr01, the fume temperature has not reached the minimum value permitted
(Pr13 parameter) with a gradient equal to 2°C/min.
If there are unburned pellets inside the burn pot, it is necessary to empty the burn put before switching on the stove again. This will
avoid wasted pellets and possible spillage within the combustion chamber.
If the pellets have begun to burn but the alarm state persists, wait until all the pellets are burning and then switch on again.
Check that there are pellets inside the hopper.
Stove operational.
At the end of the start-up phase, if no problems occurred, the stove enters its normal working mode.
If the temperature of the stove is the same as that set, the pump will come on.
Changing set room temperature
Press the P2 button to change the set room temperature. The display shows the current SET temperature state as in figure 19.
fig. 19
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eva Calor Tosca 24 kW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eva Calor Tosca 24 kW in the language / languages: English as an attachment in your email.

The manual is 4,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eva Calor Tosca 24 kW

Eva Calor Tosca 24 kW User Manual - German - 38 pages

Eva Calor Tosca 24 kW User Manual - Dutch - 90 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info