668833

Eva Calor Hydro Kantina 34 kW auto Manual

39
Zoom out
Zoom in
Previous page
1/55
Next page
8 SAFETY and ALARMS
8.1
Safety devices
CAUTION: during operation, some parts of the stove (door, handle, ceramic parts) can
reach very high temperatures.
Remember to keep at the previously mentioned safe distance.
Be careful, use caution and always follow the instructions.
If during operations any part of the stove or the exhaust pipe leak smoke, immediately turn off
the stove without removing the power supply and ventilate the room. Then, once cooled down,
verify the reason for the leak and, if necessary, call service personnel.
The stove is equipped with several devices which intervene in order to ensure safe operation.
CAUTION: safety devices are designed to eliminate any risk of damage to persons, animals or
things, and tampering with or servicing by unauthorised personnel could compromise their safety.
Safety devices on the stove include the following:
8.1.1 Fume exhaust pressure sensor
This sensor is connected to the fume exhaust pressure duct. It controls internal pressure to the
duct, monitoring any occlusion of the chimney flue and allowing use of the stove in total safety.
When it activates
If proper operation conditions in the fume exhaust duct are altered (improper installation, the
presence of obstacles or impediments in the exhaust tube, negligent maintenance, adverse
weather conditions such as persistent wind, etc.), the pressure sensor (pressure gauge) stops
electrical power supply to the pellet feed screw, thus blocking pellet feeding to the brazier and
sending an alarm signal to the board.
The alarm can also be caused by clogging in the stove, by improper combustion or lack of annual
stove cleaning.
When the alarm goes off, the display shows the message "AL 8 – LOW PRESSURE”.
What to do
- Put the stove in stand-by by pressing the off button for a few seconds (4). (The acoustic alarm
stops).
- Wait and make sure that the combustion of pellets left in the brazier has been completed.
- Wait for the stove to cool down, then verify and remove the causes which caused the safety
devices to go off. Finally, after having cleaned the brazier, re-start the stove by pressing the
ON/OFF button (4).
In the event of a repeated alarm, call a service centre.
8.1.2 Boiler /structure temperature sensor
The stove is equipped with a manual reset bulb thermostat whose function is to preserve the
boiler, pellet tank and, consequently, the whole structure from excessive temperature changes.
When it activates
For hydro stoves, if the water boiler temperature reaches a threshold of 85°C, while for air stoves,
if the pellet loading tube reaches the threshold of 85°C.
In both situations, the thermostat interrupts electrical power to the feed screw, thus blocking pellet
feeding to the brazier and sending an alarm signal to the board.
The display will show the message “AL 7 – Thermal safety”.
What to do
- Put the stove in stand-by by pressing the off button for a few seconds (4). (The acoustic alarm
stops).
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eva Calor Hydro Kantina 34 kW auto at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eva Calor Hydro Kantina 34 kW auto in the language / languages: English as an attachment in your email.

The manual is 5,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info