668828
42
Zoom out
Zoom in
Previous page
1/55
Next page
8.2
Alarms
In the event that an operating anomaly occurs, the board intervenes and signals the irregularities,
operating in different modes depending on the type of alarm. The following alarms can occur:
Cause of alarm Display message
No power AL1 BLACK-OUT
Smoke temperature sensor AL2 SMOKE SENSOR
Smoke overtemperature AL3 SMOKE TEMP
Smoke fan fault AL4 EXTRACT FAULT
No start-up AL5 NO START
Shutdown during work mode AL6 NO PELLET
General safety thermostat AL7 THERMAL SAFETY
Safety pressure switch AL8 LOW PRESSURE
No or low water sensor AL9 WATER SENSOR
Water overtemperature ALa WATER TEMP
Water press. outside allowed
values
ALb WATER PRESS
ALL ALARM CONDITIONS CAUSE IMMEDIATE STOVE SHUTDOWN
To exit from an alarm condition, always press button "4" until the message "FINAL CLEANING"
appears. You will also need to take additional steps, depending on the type of alarm generated.
If you do not exit from the alarm condition within a given time (a few hours), the alarm will be sent
into stove memory and the display will show the message "ALARM MEMORY." To exit from this
condition, press button "4" as per above.
AL 1 - Black-out
This alarm is activated when the stove is disconnected from the mains.
What to do
Put the stove in stand-by by pressing the off button for a few seconds (4).
AL 2 - Smoke sensor
This alarm signals breakage of the smoke sensor (see safety devices)
AL 3 – Smoke temp
This alarm signals excessive smoke exhaust temperature (see safety devices)
AL 4 – Extract fault
This alarm indicates a failure to read the revs of the smoke expulsion motor by the control
board. It may have been activated due to motor fault or due to a lack of connection
between the rev reader (encoder) in the motor and the board.
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eva Calor Hydro 27 kW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eva Calor Hydro 27 kW in the language / languages: English as an attachment in your email.

The manual is 5,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eva Calor Hydro 27 kW

Eva Calor Hydro 27 kW User Manual - German - 38 pages

Eva Calor Hydro 27 kW User Manual - Dutch - 90 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info