668817
41
Zoom out
Zoom in
Previous page
1/55
Next page
How it works
If water temperature exceeds the first pre-set temperature limit, the board passes into modulation
mode. The display will show the message “modulate." At the same time if, despite passage to
modulation, the water temperature continues to increase and exceeds the second pre-set safety
limit (about 90°C), the stove will pass into alarm mode.
The display will show the message “AL A – WATER TEMP”.
What to do
- Put the stove in stand-by by pressing the off button for a few seconds (4).
-
Wait and make sure that the combustion of pellets left in the brazier has been completed.
-
Verify and remove the causes which caused the safety devices to go off.
-
After having cleaned the brazier, re-start the stove by pressing button (4).
Water sensor fault
The stove constantly controls water sensor functioning.
When it activates
The water sensor fault is signalled if the sensor is momentarily and/or accidentally removed from
its housing, or the connector is not correctly positioned on the circuit board or the sensor fails for
any reason. The fault is signalled via display message AL 9 – “WATER SENSOR”.
What to do
-
Put the stove in stand-by by pressing the off button for a few seconds (4).
-
Wait and make sure that the combustion of pellets left in the brazier has been completed.
-
If necessary, call a service centre to replace the sensor.
8.1.5 Water pressure switch
The water pressure switch is directly connected to the circuit board and keeps operating water
pressure in the boiler under constant control, allowing safe use of the stove.
How it works
If water pressure goes below 0.5 bar or over 2.5 bar, the stove passes into alarm mode.
The display will show the message “AL b – WATER PRESS”.
What to do
- Put the stove in stand-by by pressing the off button for a few seconds (4).
-
Wait and make sure that the combustion of pellets left in the brazier has been completed.
-
Verify and remove the causes which caused the safety devices to go off. Check and fix
pressure level in the boiler circuit.
-
After having cleaned the brazier, re-start the stove by pressing button (4).
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eva Calor Frida at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eva Calor Frida in the language / languages: English as an attachment in your email.

The manual is 5,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eva Calor Frida

Eva Calor Frida User Manual - German - 38 pages

Eva Calor Frida User Manual - Dutch - 43 pages

Eva Calor Frida User Manual - Dutch - 90 pages

Eva Calor Frida User Manual - French - 43 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info