Manual Eurom Vento 16SR (page 10 of 44) (English, German, Dutch, French, Italian, Portuguese, Spanish)

702658

Zoom out

Zoom in

1/44

ASSEMBLY

A. front grid

B. grid locking ring

C. fan

D. grid mount

E. rear grid

F. motor shaft

G. stand protrusion

H. foot cutaway

I. pedestal

J. foot

K. fan mounting knob

L. shaft pin

Unplug from the wall socket!

 Remove the fan mounting knob (only

Vento 12&16/16SR) and the grid mount

from the motor shaft.

 Position the rear grid on the appropriate

pins. Screw it tight with the grid mount.

 Push the fan as far as possible onto the

motor shaft. Vento 12 and 16(SR):

ensure that the pins enter the grooves

and tighten the fan with the fan mounting

knob by tightening it anti-clockwise.

 Check that the fan rotates freely if you turn it by hand.

 Open the grid locking ring a little by loosening the screw a bit. Place the front grid on the

rear grid so that the grid locking ring correctly encloses the edges of the grids; the grids

firmly against each other! Then tighten the grid locking ring firmly with the screw. Check

that everything is properly lined up.

 Vento 9, 12 & 16: Run the electric cable through the hole in

the foot. Mount the pedestal on the foot, so that the

protrusions on the pedestal enter the cut aways in the foot.

Now screw the pedestal to the foot; the electrical cable will

now run through its guides (see fig.).

 Vento 16SR: Push the lower section of the stand into the

hole in the base and and screw it to the bottom of the base

with the 4 screws with washers. Screw the top section of the

stand firmly to the lower section, clockwise.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Vento 16SR in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,18 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eurom Vento 16SR Manual

Product: