702656
10
Zoom out
Zoom in
Previous page
1/44
Next page
10
ASSEMBLY
A. front grid
B. grid locking ring
C. fan
D. grid mount
E. rear grid
F. motor shaft
G. stand protrusion
H. foot cutaway
I. pedestal
J. foot
K. fan mounting knob
L. shaft pin
Unplug from the wall socket!
Remove the fan mounting knob (only
Vento 12&16/16SR) and the grid mount
from the motor shaft.
Position the rear grid on the appropriate
pins. Screw it tight with the grid mount.
Push the fan as far as possible onto the
motor shaft. Vento 12 and 16(SR):
ensure that the pins enter the grooves
and tighten the fan with the fan mounting
knob by tightening it anti-clockwise.
Check that the fan rotates freely if you turn it by hand.
Open the grid locking ring a little by loosening the screw a bit. Place the front grid on the
rear grid so that the grid locking ring correctly encloses the edges of the grids; the grids
firmly against each other! Then tighten the grid locking ring firmly with the screw. Check
that everything is properly lined up.
Vento 9, 12 & 16: Run the electric cable through the hole in
the foot. Mount the pedestal on the foot, so that the
protrusions on the pedestal enter the cut aways in the foot.
Now screw the pedestal to the foot; the electrical cable will
now run through its guides (see fig.).
Vento 16SR: Push the lower section of the stand into the
hole in the base and and screw it to the bottom of the base
with the 4 screws with washers. Screw the top section of the
stand firmly to the lower section, clockwise.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom Vento 12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Vento 12 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info