English
Technical data
Type SOLUS 400
Supply voltage Volt/Hz 220-240 / 50
Maximum capacity Watt 400
Dimensions cm Ø 8 (16,5) x 52
Weight kg 1
General safety instructions
1. Before using the machine, carefully read this entire instruction manual. Keep this
booklet in a safe place for reference.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. This heater is strictly intended for normal domestic use. Only use it as an
additional heater in your home.
4. This heater in not suitable for use in wet or damp spaces such as bathrooms and
laundry rooms. Do not place the heater in the vicinity of taps, bathtub, shower,
pool, fountains or other sources of moisture. Make sure it cannot fall into water
and prevent water from getting into the heater itself. If, at any time, the heater
does fall into water, unplug it immediately! Do not use a heater that has a damp
interior but have it repaired. Never immerse the heater, cord or plug in water and
never touch it with wet hands. Do not place the appliance in an open window to
avoid rain or on wet surfaces and avoid that no moisture spillage.
5. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected
by an earth leakage circuit breaker (max. 30 mAmp). Only connect the heater to
an earthed socket!
6. Fully extend the cord before plugging in the heater. Make sure it does not come
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips, or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use! Do
not rotate or kink the cable and do not wind it around the stove as this can
damage the insulation!
7. If possible, do not use an extension cord, as this poses the risk of overheating
and fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 3 x 1.0 mm²
and a minimum permissible power of 1000 Watt/3Amp. To prevent overheating,
always fully extend the cord!
8. Insert the plug into the socket before the appliance is installed correctly and is in
its final position.
9. Do not use the heater in dusty spaces, outside or in spaces smaller than 15 m².
10. A heater contains hot and/or glowing and sparking components. Do not,
therefore, use it in areas where fuels, paint, flammable liquids and/or gasses etc.
are stored.
