474871

Eurom QH 1503 Manual

11
Zoom out
Zoom in
Previous page
1/28
Next page
11
Preferably place the heater in its original packaging. In any case, provide dust-free storage in a cool and
dark room.
Save these instructions to enable you to consult them against in the future if required.
POSITIONING
Carefully remove the packaging and keep out of the reach of children. Pay attention to the mounting
material!
Before use, check that the device is free from damage or signs that may indicate an error/defect/failure.
If in doubt, do not install or use the heater, but return it to the supplier!
This heater has been designed to be hung horizontally from a wall; therefore do not use it whilst it is
standing, lying or in any other way!
Carefully choose the place where you wish to attach the heater to the wall. Make sure that the base is
firm, flat and non-combustible. Do not position the heater just below or above a socket or close to heat
sources such as cooking rings, etc.
The heater has to hang at least 180 cm above the floor and at least 50 cm below the ceiling. Should you
wish, at any time, to direct the radiation upwards, the distance to the ceiling has to be 100 cm, certainly
when there is a plastic or combustible ceiling. Maintain a distance of at least 50 cm from side walls. Do
not position the heater behind a door!
The insulation of the heater is IP24 rated (splash proof) and therefore suitable for use in bathrooms. A
distance of at least 1 m has to be maintained between the heater and baths, taps, fountains, showers
etc. Make sure that no jets of water can be directed at the heater and that the heater cannot fall into the
water.
Only connect the heater to an earthed socket!
When positioning and connecting the heater, make sure that your hands do not touch the heating ele-
ments. This is because traces can be left behind which, afterwards, will have a negative effect on the ra-
diated heat.
For use with a plug, the following applies: do not use extension leads and do not connect any other
equipment next to the heater in the same socket!
At the spot that you have selected, having taken into account the safety instructions, now drill 4 holes
into the wall, with a horizontal distance of 119 mm and a vertical distance of 41 mm (see drawing). Make
sure that the holes are positioned perfectly horizontally and vertically from one another. Tap the plugs in-
to the drilled holes and screw in the supplied screws until a few millimetres remain between the head of
the screw and the wall.
The rear of the heater has four suspension eyes. Position these with the wide part over the screw heads
and lower the heater until it can go no further (approx.1 cm).
Turn the body of the heater upwards as far as possible and mark the spot where the locking screw has
to be inserted (through the small hole at the bottom of the mounting bracket). Remove the heater from
the wall, drill the hole for the locking screw and tap a plug into this. Again hang the heater up and turn
the locking screw through the bracket in the wall. Your heater has now been secured.
Turn the heater to the required position. The body of the heater can be turned to 5 positions. The mid
position is horizontal to the room. The two positions which are directed upwards will only be used in ex-
ceptional cases and require a greater distance to the ceiling (1 metre). Finally, the heater has two posi-
tions which are directed downwards.
The heater is now ready for use.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom QH 1503 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom QH 1503 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info