58
Setting weekly timer
• Press the WEEK button and hold it in. A blinking ‘01’ will now appear on the display.
Use the + and – buttons to choose “01” (one-off setting) or “][“ (the setting your install
will be implemented every week). Confirm with SET.
Note: the setting(s) that you enter under 'one-off' (01) must fall into the current week. On
Sunday (day 7) at 24.00, all one-off settings will be turned to non-active. A setting that you
enter on Tuesday for Saturday will work, but a setting that you enter on Saturday for
Tuesday will not.
Note: a one-off setting (01) will only be implemented by the heater once, but the timer
setting will stay as non-active in the memory and therefore takes the place of one of the
four possible settings on that day. You are better off deleting it, see later.
Please Note: The choice of 'one-off' or 'repeated' now applies to all timer settings!
• “01 SET ON” appears on the screen to signify that you can set the first 'on' time. You
can now use the + and – buttons to select the day of the week for the setting. Press SET
for the right day.
• The temperature (standard 25°) now appears on the display and blinks. Use the + and –
buttons to adjust it, from 0 to 37°C. Confirm with SET.
• The hour will now blink. Choose the right hour and confirm with SET.
• The minutes will now blink. Choose the right minutes and confirm with SET. The first
activation time is now set.
• Now, “01 SET OFF” will appear on the display, to indicate that you must set the
deactivation time. Do this in the same way as set out in the above 2 points. Your first
setting is now entered.
A ‘02’ will now appear on the display. You can now set a second
activation/deactivation time; a total of 4 per day and 28 per week. If you don't
need to, wait until the screen returns to the standard settings.
Attention! All timer settings (maximum 28 per week) will be processed completely one by
one. Therefore, make sure that they do not contradict each other!
• Now switch the heater on using the ON/OFF switch. The screen will show P and OFF to
indicate that a setting has been programmed but that the heater is currently off. At the
set time, it will switch on and off automatically.
• The set timer details will be retained after it is switched off using the main switch or
plug.
• If you press repeatedly on WEEK, you will see the following timer settings, one after the
other:
- One-off or repeated
- Thermostat setting
- Timer on-time
- Timer off-time
- Next timer setting
• If you would like to delete a specific setting, press and hold WEEK and then search for
the timer setting that you need. Go past 01- ][ and on/off first by pressing SET briefly.
