English
Thanks
Thank you very much for choosing for an EUROM device. You have made a good
choice! We hope you will be satisfied about its functioning.
To get maximum profit from your device, it is important to read this manual attentive and
totally before use, and to understand what is written. Read especially the safety
instructions: they are there to protect you and your environment.
Keep the Instruction booklet in a safe place for future reference. Store also the package:
that is the best protection for your device in times of no-use. And if you at any time pass
the appliance on, pass on the manual and package too.
Technical data
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug and Smart Plug
control panel, for any visible damage. Do not use a damaged heater, but send it back
to your dealer for replacement.
3. Do not use the heater until it is been fully installed in accordance with the instructions
under the heading ‘Description, Composition and Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the
(additional) heating of your home.
5. This heater and the Smart Plug control panel are not suitable for use in wet or damp
spaces such as bathrooms and laundry rooms. Do not place both in the vicinity of
taps, bathtub, shower, pool, fountains or other sources of moisture. Make sure they
cannot fall into water and prevent water from getting into the heater and Smart Plug
control panel themself. If, at any time, the heater does fall into water, unplug it
immediately! Do not use the heater and Smart Plug control panel that has a damp
interior but have it repaired. Never immerse the heater, Smart Plug control panel,
cord or plug in water and never touch it with wet hands.
6. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. Only use an undamaged, earthed socket that is
secured with a 30 mA earth leakage circuit breaker. The electrical socket that you are
using must be to hand at all times in order to be able to remove the plug from the
socket in the event of an emergency
7. Fully extend the cord of the heating panel before plugging in the socket. Make sure it
does not come into contact with any part of the heater and prevent it from heating up
any other way. Do not lead the cord around sharp corners and do not roll it up too
tightly after use!