Remote control:
1. ON/OFF button
2. C (Cancel) button
3. Open-window detection button
4. SET button
5. OK button
6. EDIT button
7. ECO button
8. TEMP (temperature) button
9. Time on / Time off button
10. Higher (+)button
11. Lower (–)button
12. WEEK button
Operation using the control panel on the heater
Make sure the heater is firmly attached to the wall. Turn the main switch ON.
The symbol indicating the capacity lights up and the WiFi symbol flashes on the
display of the heater. When the WiFi symbol flashes, you can make a connection.
1. Press the ON/OFF button on the control panel.
First the heater’s display shows the set temperature for 3 seconds and
subsequently, the ambient temperature. (The set temperature is the most
recently set temperature or 20 °C in case of first use.)
If the set temperature is higher than the ambient temperature, the heater will
start to heat and the heating symbol will appear.
2. Using the + and – buttons, the set temperature can be adjusted from 0 °C to 37
°C). If the set temperature is higher than the ambient temperature, the heater
will start to heat and the heating symbol will appear.
When the set temperature is reached, the heater will automatically switch OFF
and will switch ON again when the room cools down.
The heating symbol will disappear and re-appear accordingly.
If no button is pressed during two (2) minutes, the ambient temperature will
disappear from the display. Pressing any button will make the ambient temperature
re-appear.
Setting the time and day on the heater using the control panel
Using the M button, the time and day of the week can be entered so that you can
use the timer function.
The heating panel should be ON, but should NOT heat and therefore, there is no
heating symbol visible on the display. (Do this by setting the temperature lower
than the ambient temperature, for example.)
