Cautions before use
For indoor use only.
Always keep the unit in vertical position. If the device is not stable and upright,, water
from the tank can get into the interior of the device and damage something or cause a
dangerous situation!
Before moving, cleaning or perform maintenance on the unit, first switch off, then
unplug and empty the water tank. Pull on the plug to remove from the socket, never
pull on the cord.
Leave the unit to stand for one hour before connecting to the mains supply after
transport or when it has been tilted (max. 45°, e.g. during cleaning).
Keep air-intake or output openings clean and unobstructed. Prevent foreign objects or
fingers from entering the equipment via the venting or exhaust openings as this may
lead to electric shock, fire or damage.
The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected by an
earth leakage circuit breaker (max. 30 mAmp). Only connect the equipment to an
earthed socket!
Fully extend the cord before plugging in. Do not run the cord underneath carpeting; do
not cover it with mats, carpet strips, or similar and make sure it is not placed in any
passageways. Make sure the cord cannot be stepped on and that no furniture is
placed on top of it. Prevent that the cable gets hot. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
If the supply cord is damaged, it must be replaced by an approved service
representative or a similar qualified person in order to avoid a hazard.
Never use the plug to start and stop the unit. Always use switch on the control panel.
Don't use bug sprays or other flammable cleaners on the unit. Do not expose the
device to the influence of chemicals.
Never pour or spray water over the unit.
