591495

Eurom Heat-Duct-Pro 9 Manual

17
Zoom out
Zoom in
Previous page
1/56
Next page
17
English
Technical data
Type
Heat-Duct-Pro 3
Heat-Duct-Pro 9
Supply voltage
V / Hz
220-240 / 50
400 - 3~ / 50
Maximum capacity
W
3000
9000
Settings
W
0 - 3000
0 – 4500 - 9000
Air flow
m³/h
389
1227
Protection class
IP24
IP24
Electrical cable
H05RN-F 3G1.0mm²,
150cm.
H07RN-F 5G1,5mm²
150cm
Plug
Schuko
5 pole – 16A
Dimensions
cm
36,5 x 26,5 x 37
46 x 31,5 x 42
Weight
kg
6
11,7
General safety instructions
1. Before using the machine, carefully read this entire instruction manual. Keep this
booklet in a safe place for reference.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. This heater is exclusively intended to heat workspaces such as workshops,
garages and storage spaces. Use the appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the heater can be used in
wet or damp indoor spaces such as bathrooms and laundry rooms. Do not place
the heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources
of moisture. Make sure it cannot fall into water and prevent water from getting into
the heater itself. If, at any time, the heater does fall into water, unplug it
immediately! Do not use a heater that has a damp interior but have it repaired.
Never immerse the heater, cord or plug in water and never touch it with wet
hands.
5. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected
by a residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make sure it does not come
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips, or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use! Do
not rotate or kink the cable and do not wind it around the stove as this can
damage the insulation! Be carefull! Some parts of this product can become very
hot and cause burns. Particular attention has to be given where children and
vulnerable people are present. do not let bare skin come into contact with hot
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom Heat-Duct-Pro 9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Heat-Duct-Pro 9 in the language / languages: English, German, Dutch, French, Swedish as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info