9. The user and persons who must be in the vicinity must wear
protective clothing and footwear. We strongly recommend that you
use hearing protection.
10. Do not spray flammable liquids an do not use the cleaner in
circumstances or environments where there is a danger of
explosions. Risk of explosion!
11. Always take the plug out of the socket when carrying out
maintenance on the machine, before you change the nozzle and
when the cleaner is not in use. For that, take the plug in your hand.
Never operate plug and / or appliance with wet hands!
12. Water that has been in the machine, the hose or the nozzle is
unsuitable for consumption.
13. Do not use the machine at temperatures exceeding 40°C or under
2°C, and keep it frost-free.
14. Never change anything on the machine, the jet lance, the nozzle or
any other component.
15. Never cover the machine, jet lance, nozzle or any other part during
use.
16. Switch the machine off immediately in the case of accidents or
power failures.
17. Only spray clean water. If you spray water that may contain, for
example, sand (from a well or similar source) an extra filter must be
installed.
ASSEMBLY
Position the washer as near as possible to the water supply..
The cleaner must be placed on a strong, flat and horizontal surface (handle up) (see fig. 3).
Decide which jet lance you wish to use: with narrow/flat jet, with rotating head or possibly the terrace
cleaner. Insert the end of the relevant lance into the jet pistol and screw it firmly in place (see fig. 4).
Screw the high-pressure hose onto the jet pistol (see fig. 5). Tighten firmly using the no. 17 spanner.
Connect a normal ½” garden hose (reinforced) of min. 5m. and max. 25m. to the water supply and
turn it on for a short time in order to flush any dirt out of the hose. Now use a quick connector to
connect the hose to the water inlet (see fig. 7).
Attention!
The water temperature may not exceed 40°C.
The pressure of the water supplied may not exceed 0.7 MPA (7 bar).
Only use clean water with this machine. Impurities or aggressive chemicals damage the machine!
Turn the On/Off switch to the OFF 0 position (see fig. 9).
Check that the specifications of the socket that you wish to use correspond with those on the type
plate of the machine. If this is the case, insert the plug into the socket.
OPERATION
Open the water supply completely.
Unlock the safety lock by pushing the button to the right (see fig. 8).
Now squeeze the trigger for several seconds in order to de-aerate the hose.
Switch the machine on by switching the On/Off button to I ON (see fig. 9). The motor will start briefly,
but will stop again as long as the trigger is not squeezed.
