• High pressure cleaners shall not be used by children or untrained
personnel.
• High pressure hoses, fittings and couplings are important for the safety of
the machine. Use only hoses, fittings and couplings recommended by the
manufacturer.
• To ensure machine safety, use only original spare parts from the
manufacturer or approved by the manufacturer.
• Water that has flowed through backflow preventers is considered to be
non-potable.
• The machine has to be disconnected from its power source during
cleaning or maintenance and when replacing parts or converting the
machine to another function always remove the plug from the socket-
outlet.
• Do not use the machine if a supply cord or important parts of the
machine are damaged, e.g. safety devices, high pressure hoses, trigger
gun.
• Inadequate extension cords can be dangerous. If an extensions cord is
used, it shall be suitable for outdoor use, and the connection has to be
kept dry and off the ground. It is recommended that this is accomplished
by means of a cord reel which keeps the socket at least 60 mm above the
ground.
• Make sure that the line cord and the extension cord are not damaged by
stepping on them, squeezing, dragging or something similar. Protect the
line cord against heat, oil or sharp edges.
• Always switch off the mains disconnection switch when leaving the
machine unattended.
• Depending on the application, shielded nozzles can be used for high
pressure cleaning, which will reduce the emission of hydrous aerosols
dramatically. However, not all applications allow the use of such a device.
If shielded nozzles are not applicable for the protection against aerosols, a
respiratory mask of class FFP 2 of equivalent may be needed, depending
on the cleaning environment.
General safety instructions
• The minimum diameter of the water connection (hose) is 12.7mm (1/2”).
• The water supply must supply at least the water consumption of the device (330 l/h)!
The pump must always be supplied with sufficient water. ’Dry operation’ causes damage.
• The water temperature may not exceed 40 °C.
• Only use clean water with this device. Impurities or aggressive chemicals damage the
device!
• The voltage and frequency stated on the device must correspond to those of the socket.
The electrical system must be approved (IEC 60364-1) and secured with an earth leak
switch (max. 30 mA). Never make any changes to the plug or socket in order to adjust
them! Defectiveness in the electric connection could result in a shock!
