EN
BEFORE USING YOUR PUMP…
Read this entire instruction leaflet carefully. It contains important information in
relation to the use of your pump and precautionary measures that may need to be
taken. Reading these instructions thoroughly will ensure you get the very best
performance from the product and ensure maximum safety. Any use, other than set
out in this leaflet, could cause damage, injury and represent a hazard; it will also
invalidate the guarantee.
Keep this booklet in a safe place for reference.
SAFETY RECOMMENDATIONS
Before using your new pump, check it, including cord and plug, for any visible
damage. Do not use a damaged pump, but send it back to your dealer for
replacement.
For safety reasons, your submersible pump must always be connected to an
earthed socket that has been installed according to national regulations, forms
part of an electricity network that is equipped with a fuse of at most 16 Amp and
has an earth leakage circuit breaker (nominal voltage ≤30 mA).
Check your pump, electrical cable, plug and socket before each use. Do not use if
the device is damaged and have this damage repaired by an accredited
electrician. The cable is an H05RN-F 3G 1.00mm² type.
Ensure that electrical connections stay dry at all times. Do not touch them with
wet hands.
Before use, ensure that the socket to which you are connecting the pump is
suitable for the pump itself (see type plate).
Protect the electrical cable and plug from heat, oil and sharp corners.
Clean the drainage pipe before use.
Before use, check to ensure that elevation height does not exceed your pump’s
capacity.
Do not use the electrical cable to hang up, lower or move the pump. Attach a rope
to the handle in order to do this. Never pull on the cable to remove the plug from
the socket but remove by pulling on the plug!
Rinse the pump with clean water if you have used it to pump water that contains
chlorine, for example, or deposits. Bear in mind that sand and all other abrasive
and corrosive substances will increase wear and tear and impact upon the
effectiveness of the pump.
Ensure the pump is not used if it cannot drain off the water due to issues such as
blocked drainage, elevation too high, etc. This will damage the pump!
Do not use the pump if there are persons present in the object to be pumped out.
It is forbidden to use this pump in a swimming pool.
