635876
43
Zoom out
Zoom in
Previous page
1/64
Next page
43
Problems And Solutions
The heater burns but switches off after a short period
The light blinks, display shows E1
Incorrect pump pressure
Dirty air filter
Dirty fuel filter
Nozzle dirty
Photoelectric cell lens dirty
Photoelectric cell not installed
correctly
Photoelectric cell defective
Bad electrical connection between
photo cell and PCB
Check pump pressure and adjust if
necessary
Clean/replace air filter
Clean/replace fuel filter
Clean/replace nozzle
Clean the lens
Install correctly
Check and replace photoelectric cell
if necessary
Check electrical connection and
repair where necessary
The heater is not working or the motor runs for a short time only.
The light blinks, display shows E2
No fuel in the tank
Incorrect pump pressure
Spark plug dirty or plug opening
incorrect
Dirty fuel filter
Nozzle dirty
Dirt in fuel or tank
Bad electrical connection between
transformer and operating panel
Ignition wire not connected to spark
plug
Broken ignition
Add fuel
Adjust pump pressure
Clean spark plug, adjust or replace
Clean/replace fuel filter
Clean/replace nozzle
Replace fuel and clean tank with
paraffin
Check all connections, see wiring
diagram
Connect the ignition cable to the
spark plug
Replace the ignition
The fan does not work but the heater comes on.
The light blinks or stays on and the display shows E1 or E2
Thermostat settings too low
Electrical connection between the
operating panel and motor is broken
Set thermostat higher
Check all electrical connections
Bad combustion or excess formation of soot
Dirty inlet, outlet or lint filter
Dirty fuel filter
Bad fuel quality
Pressure is too high or low
Clean or replace filters
Clean or replace filter
Do not use dirty or old fuel
Set the right setting
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom Fireball 20T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Fireball 20T in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info