30
The mode selector dial with 4 positions is located on the left:
- O or off
- fan only
- 3300W power (low)
- 5000W power (high)
The continuously adjustable thermostat dial is located on the right.
Location and connection
Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Check if the control switch is set to 'OFF' (O).
Fully extend the power cord and plug into a suitable 400 V socket. To prevent
the circuit overloading, check that no other appliances are connected to the
same group.
Set-up and operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far as
it goes).
With the mode selector dial, adjust the heater to suit your preferences: fan only,
low power or high power. It is most economical to heat the space at full power,
then to switch to half power to maintain the temperature.
Both at half and full power, the fan rotates at the same speed; the difference
between the two lies in the number of heating elements in use.
Once the desired temperature is reached, turn the thermostat dial back slowly until
you hear a click. The temperature is now set. The heater will automatically switch
on and off to maintain the set temperature.
Note! After the thermostat has switched the heating elements off, the fan will keep
turning. This means that the air is constantly moved, allowing the heater to
accurately detect if the area is cooling down.
To set a higher or lower temperature, turn the thermostat dial either clockwise or
anticlockwise.
Switch off:
If you want to switch the heater off, first set the control knob to 'ventilate' and
allow the heater to cool for 2 minutes. To switch the heater off, set the control
switch to ‘0’ (off). Unplug.
