701883

Eurom E-Convect defrost 400 - tot 2018 Manual

15
Zoom out
Zoom in
Previous page
1/48
Next page
15
English
Technical data
Type
E-convect
defrost 400
E-convect metal
1000
E-convect
metal 1500
Supply Voltage
V/Hz
220-240 / 50
220-240 / 50
220-240 / 50
Maximum capacity
W
400
1000
1500
Thermostat
+
+
+
Protection class
IP24
IP24
IP24
Dimensions
cm
8,5(20)x33x28,5
8,5(20)x66,5x28,5
8,5(20)x95x28,5
Weight
kg
1,3
2,3
2,9
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. Do not use the heater until it is been fully installed in accordance with the
instructions under the heading ‘Description, Composition and Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the
additional heating of your home.
5. Under the terms and conditions described in this leaflet, the heater can be used in
wet or damp indoor spaces such as bathrooms and laundry rooms. Do not place
the heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources
of moisture. Make sure it cannot fall into water and prevent water from getting into
the heater itself. If, at any time, the heater does fall into water, unplug it
immediately! Do not use a heater that has a damp interior but have it repaired.
Never immerse the heater, cord or plug in water and never touch it with wet
hands.
6. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The socket used needs to be earthed and the
electrical installation needs to be secured with a ground-fault circuit interrupter
(max. 30 mAmp).
7. Fully extend the cord before plugging in the heater. Make sure it does not come
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating
and fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 3 x 1.5 mm²
and a minimum permissible power of 500W (E-Convect defrost 400) / 1200W (E-
Convect metal 1000) / 1750W (E-Convect metal 1500). To prevent overheating,
always fully extend the cord!
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom E-Convect defrost 400 - tot 2018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom E-Convect defrost 400 - tot 2018 in the language / languages: English, German, Dutch, French, Swedish as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info