Because the temperature sensor is located on the
heater, the measurement is not particularly accurate.
If you want a more accurate measurement, connect
the separate thermostat supplied by inserting the plug
under the control panel and moving the sensor two
meters away from the heater, see the illustration.
When you have plugged in the separate thermostat, it
will automatically take over the thermostat function.
The display will switch off if you change nothing in the settings for 10 seconds. You
can reactivate it by pressing once on any button at random.
Press the ON/OFF button first in order to switch the device E-convect off. The heater
is now in standby mode. Now switch the main switch off (O); the lamp will go out.
Finally remove the plug from the socket.
Timer
The Mon Soleil Wifi has a timer function that can be used with the app on your
smartphone
Wi-Fi and app operation
The heater can also be controlled with an app on your smartphone. To do this, the
heater must be connected to a Wi-Fi modem. To install the app, refer to the end of this
booklet.
Safety feature
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the heater,
or installing the heater too close to a wall or something similar. In case of overheating,
switch off the heater and unplug. Give the heater time to cool down, remove the source
of the overheating and use as normal. If the problem persists or if you have not been
able to trace the source of the overheating, turn the heater off immediately and unplug.
Contact a servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow
the heater to cool down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions!
You can keep the back of the heater free of dust with a feather duster. For thorough
cleaning of the back, you can unscrew the heater from the wall.
If you want to clean away the E-convect at the end of the season, you can simply
unscrew it and store it, if possible in the original packaging, upright in a cool. Dry
and dust-free place.
CE-statement
Eurom - Genemuiden-NL hereby declares that the EUROM electrical convector
heater, type E-CONVECT WIFI, complies with the LVD guideline 2014/35/EU, EMC
guideline 2014/30/EU, RED guideline 2014/53/EU and meets the following standards:
