Warning: Take note of the water level during operation!
Cleaning and maintenance
Switch off the equipment and remove the plug from the socket before cleaning or
carrying out maintenance work.
Wipe the outside of the equipment regularly with a dry or slightly damp cloth.
Do not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions! Ensure that the operating panel does not get wet.
The device should be cleaned bi-weekly to
prevent odours, bacteria and lime scale and to
ensure proper operation. To take out the dust
filter, including the evaporation element (8),
remove both screws at the rear of the device.
Carefully remove the honeycomb evaporation
element from its holder. (By bending the holder
slightly outwards, you create room to take out
the honeycomb evaporation element undamaged
from its holder.) Carefully clean the dust filter and the honeycomb evaporation
element using a soft brush or under mildly running water, and let them dry
thoroughly. Do not damage or deform the honeycomb evaporation element.
Before you return the entirety into its place, check whether the drain holes in the
synthetic element-holder are not clogged. If necessary, clear these drain holes.
Install all the components in their original position.
Never use the device without a completely assembled element, otherwise you
risk water damage!
Pull the water tank out of the appliance as far as possible (± 15 cm), first
remove the pump in the water tank by turning both balls that hold the pump in
place. Now you can remove the pump. The water tank can now be removed in
its entirety. Empty the water tank and clean it thoroughly.Pump should also be
cleaned once a month or when very dirty or in case of a malfunction. The pump
is in the water reservoir. Then turn both tabs that hold the pump in place, away.
Now you can remove the pump. Click the filter (the side with the diagonal
