47
Description LED display remote control
1. Signal reception wirelessly
2. Cooling function
3. Dehumidifying function
4. Fan function
5. Swing function
6. Timer set number of hours
7. Timer on / off
8. Sleep function
9. Fan speed
10. Temperature display
The control panel en the remote control have basically the same buttons.
At the back of the remote control, insert two batteries (AAA-1.5V) into the
appropriate compartment.
Before using the air conditioner, check:
That it has been installed according to safety instructions
That it is not damaged or broken
That the electrical socket that you wish to use has the same voltage as is given
on the unit’s specification plate (220-240V~50Hz)
That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket.
Switch the device on with the ‘power’ button.
Cooling function
Press the ‘Mode’ button until the ‘Cool’ light is shown on the display.
The display shows 25°C.
Set the required temperature with the Temp ▲ / Temp▼ button. The display
shows the configured temperature. The temperature can be set between 16 and
31°C.
Press the ‘Speed’ button to set the ventilator speed at silent, normal or turbo.
Observe an interval of at least 3 minutes between every on/off.
Dehumidification function
Press the ‘Mode’ button until the ‘Dehum’ light is shown on the display.
Check if the water discharge is connected correctly.
The display automatically shows 2°C below the room temperature.
The temperature cannot be changed.
The ventilator speed is automatically set to silent.
Observe an interval of at least 3 minutes between every on/off.
