510002
6
Zoom out
Zoom in
Previous page
1/16
Next page
6
User and installation instructions
Use
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The electric fan heater is intended for space heating in various premises. It is movable, but can also be permanently in-
stalled. The electric fan heater is approved for use in humid and wet areas, and is employed on building sites, in stores
and shops, and in the home. The fan heater has been subjected to electrical safety testing and EMC-testing by SEMKO.
The fan heater is CE marked. Degree of protection: IP X4 (corresponds to splash-proof)
Safety
Don’t use this heater in the immediate vicinity of a shower, bath or swimming pool.
Don’t cover the heater since it could then overheat and could cause a fi re (see also
Figure A).
Some of the heater surfaces become hot when the heater is in operation.
Locate the heater so that any combustible material will not be ignited.
Don’t locate the heater immediately below a permanent wall-mounted power outlet.
If permanently installed in a bathroom or shower room, make sure that the heater is
installed so that the person using the bath or shower will not be able to touch it.
Operation
Thermostatically controlled fan motor
The fan motor will stop when the thermostat has
switched off the heater.
1. Fan (BX 9AE Low speed)
2. Fan + 1/2 output (BX 5E 230 V - 2/3 output)
3. Fan + 1/1 output
Continuous operation
The fan motor runs continuously regardless of the thermostat setting.
4. Fan (BX 9AE High speed)
5. Fan + 1/2 output (BX 5E 230 V - 2/3 output)
6. Fan + 1/1 output
Thermostat, 0 – 35°C
7. The thermostats in BX 2E and BX 3E have one output stage, while other models have two output sta ges.
Cleaning
Clean the heater at regular intervals, since dust and dirt may cause overheating and give rise to the risk of fi re.
Service and repairs
The following work should be done by personnel from the manufacturer or a service company, or by equivalent qualifi ed
personnel:
Changing the power supply cable.
The heater has a built-in temperature limiter that will trip the power supply in the event of overheating.
If the temperature limiter has tripped, isolate the power supply to the heater, allow the heater to cool down and attend to
the fault.
Permanent installation
For stationary duty, the heater should be mounted at least 1800 mm above the fl oor. The minimum distances from the
ceiling and wall are shown in Figure B. Secure the heater fan to the wall with screws fi tted through the two mounting ho-
les, and make sure that the heater is fi rmly secured in position. Use an all-pole switch with a distance of at least 3 mm
between open contacts for connecting the heater to the power supply. Check the rating plate of the fan and the wiring
diagram on the cover to make sure that the installation has been correctly done. The installation must be carried out by
an authorized installer and in accordance with the relevant regulations.
GB
A
1
2
3
4
5
6
7
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom BX 3E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom BX 3E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info