REPLACING A BULB
Warnings:
Always unplug the fireplace before replacing
a bulb!
The bulbs get hot during use; allow plenty of
time for them to cool down before touching
them!
The two lamps are located behind the small
panel at the rear of the fire. To get to the
lamps you must unscrew two screws that
keep the panel in place. Slide the panel
downwards and remove it (see figure).
Unscrew the broken lamp and replace it by a
25W E14 SES clear candle lamp. Do not
screw in the lamp too tight!
Refit the panel and tighten the screws.
SAFEGUARDS
The Barcelona atmospheric fireplace is equipped with an overheating safeguard.
The overheating safeguard switches the heater off if it overheats internally. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the
heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar.
If this happens, turn the fireplace off by switching the main switch to O and remove
the plug from the socket. Leave the fireplace to cool down for at least 15 minutes
and remove the cause of overheating. You can then switch the fireplace back on.
If the device overheats again or you cannot ascertain the reason for this, take the
fireplace to your service point to be checked/repaired.
Important! For safety reasons the fire will not automatically restart after
overheating. Check whether conditions are safe before switching it on! So never
switch on the heater by means of a timer and never connect it to a power supply
that regularly switches on and off.
