807581

Eufab 16518 - CB20 Manual

10
Zoom out
Zoom in
Previous page
1/24
Next page
10
Set the power switch to the "OFF" position.
6.2.5 REMOVING THE CHARGER
First pull the plug out of the socket and observe
the sequence for disconnection. This prevents
sparks from forming. Since charging generates
a detonating gas, this is particularly important
for the sake of your safety.
CAUTION
Disconnect the charger from the mains power supply.
Next, remove the black negative (-) cable. Now, remove the
red positive cable (+) from the positive pole of the battery.
Let the battery cool down.
Only for open batteries: Fill the cells with distilled water
up to the level speci ed by the battery manufacturer. Close
the battery cells with the stoppers.
The green 30 A  at fuse can blow if the pole clamps touch
each other when the unit is switched on.
In this case, switch the battery charger o and disconnect the
mains plug from the socket. Pull the fuse out of the holder
and replace it with a new, equivalent fuse.
6.3 TROUBLESHOOTING
6.3.1 IN CASE OF SHORT CIRCUIT
Figure 5: 30 A fuse
In the event of overvoltage in the power supply system, the
5 A glass fuse may blow. In this case, switch o the battery
charger and disconnect the mains plug from the socket.
Unscrew the fuse holder. Replace the fuse with a new
equivalent one
(Ø 5 x 20 T 5 A).
6.3.2 IN CASE OF OVERVOLTAGE
Figure 6: T 5 A fuse
If other faults or defects occur, contact our customer service
department (see section 9) or consult a specialist electrical
workshop.
6.3.3 OTHER FAULTS
Never open the device yourself to attempt
to repair it. This is potentially fatal!
The battery charger is maintenance-free when used in
accordance with the intended purpose.
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
Clean the pole callipers after the charging process is
completed. Remove all splashed battery acid from the pole
callipers to prevent corrosion. Clean the device carefully with
a dry cloth. Do not use liquids or chemical cleaning agents.
Never submerge the device in liquid. Never allow liquids to
run over the device or to get inside.
Properly roll up the cable before storing the device to prevent
damage to the cables and the device. Store the device in a dry
and clean location.
7.2 CARE
The packaging is made up of environmentally
friendly materials which may be disposed of
via your local recycling points.
Do not put electrical devices into the
household waste.
Electrical and electronic scrap must be
collected separately and disposed of in an
environmentally responsible manner for
recycling. Please contact your community or
city administration regarding disposal options
for electronic scrap.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eufab 16518 - CB20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eufab 16518 - CB20 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1.15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info