Manual Eufab 11583 - Crow Plus (page 13 of 28) (English, German, French, Italian)

807231

Zoom out

Zoom in

1/28

Figure 7: Mounting the retaining clips

Figure 9: Tightening the wheel rail

Step 5:

Step 7:

Step 6:

Fasten the brackets for the lamp holders to the outside

of the frame extension using the screws and spacers

(mounting material position 5 in the overview) (left

and right).

The rounding of the holder clamp must point

downwards.

Fasten the wheel rail with the lock bolts, washers and nuts

(installation material position 5 in the overview). After

tightening the nuts, place the protective caps on the

nuts (left and right).

Place the wheel rails with the hinge on the frame

extension. Make sure that the nut with the protective

cap of the hinge points backwards (left and right).



Figure 10: 3 x short tensioning strap

Figure 11: Mounting the tensioning straps

Laying electrical cables

Mounting the short tensioning strap

Lay the cables along the tube of the base frame. The

cables may not be bent, stretched or crushed, e.g.

in the vicinity of the folding mechanism. Secure the

cables with the supplied cable ties (Position 6 in the

overview). When you are  nished, trim any excess

material from the cable ties using cutting pliers.

Insert the short tensioning strap from the inside to

the outside below the bike holder and then from the

outside to the inside through the slots of the bike

holder (Figure 11). For the rear wheel of the bicycle,

use the centre slot of the wheel holder, for the front

wheel, use the two outer slots (two tensioning straps to

prevent the front wheel from turning).

Fig. 5

Nut with protective cap to the rear

Fig. 6

Fig. 7

Figure 8: Mounting the wheel rail

Figure 6: Inserting the retaining screws

Step 4:

Replace the retaining screws (left and right).

Fig. 4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eufab 11583 - Crow Plus in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3.57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eufab 11583 - Crow Plus Manual

Product: