667559

Etna VWT349WIT Manual

41
Zoom out
Zoom in
Previous page
1/58
Next page
EN 13
Adding salt
This machine is equipped with a water softener. To use the water
softener, fill the dishwasher with salt.
1. Remove the bottom basket and then unscrew the cap from the
reservoir.
2. Before filling the reservoir for the first time, pour in one litre of water.
3. Insert the funnel into the reservoir opening. Pour in approximately
0,5 kg of salt. It is normal for a little water to flow out of the opening
when doing this.
4. Screw the cap back on firmly.
Attention!
• Clear up any spilled salt and always run a full cycle immediately
afterwards to prevent damage to the bottom.
• Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher. Refill the salt reservoir when the water
softener indicator lights up. It is possible that the light will remain
lit for a short while after the salt reservoir is filled. It will go out
automatically when enough salt has been dissolved in the water.
• Never fill the salt reservoir with dishwasher detergent. This will
cause irreparable damage to the water softener.
Setting the salt consumption
You can adjust the amount of salt consumed based on the hardness of
the water used. Proceed as follows:
1. Within 60 seconds after switching on the diswasher: Press the
start/reset button for 5 seconds. The rinse aid warning light and the
water softener warning light will flash alternatively.
2. Select the level of salt consumption by repeatedly pressing the
program selector button. Each program corresponds with a certain
setting, see the table below.
Water hardness Water softener
setting
Number of light and sound signals
ºdH mmol/l
0 - 5 0 - 0,9 1
H1: RAPID
6 - 11 1,0 - 2,0 2
H2: 1 HOUR
OPERATION
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna VWT349WIT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna VWT349WIT in the language / languages: English, Dutch as an attachment in your email.

The manual is 5,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info