Manual Etna T 201 (page 16 of 45) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

71807

Zoom out

Zoom in

1/45

- 17 -

ENGLISH

GENERAL

Carefully read the contents of this leaflet since it pro-

vides important instructions regarding safety of installa-

tion, use and maintenance.

Keep the leaflet for possible future consultation. All the

operations relating to installation/replacement (electrical

connections) must be carried out by specialised

personnel in conformity with the regulations in force.

SAFETY WARNINGS

It is recommended to use flat-bottom pans with a diam-

eter equal to or slightly larger than that of the heated

area. Do not use pans with a rough base to prevent

scratching the heat surface of the cooktop (Fig.2).

This appliance is not suitable for use by children or per-

sons requiring supervision. Do not let children play with

the appliance.

IMPORTANT

- Avoid spilling liquid, therefore to boil or heat liquids,

reduce the heat.

- Do not leave the heating elements on with empty pots

and pans or without receptacles.

- When you have finished cooking, switch off the rel-

evant heating element with the control indicated

below.

ATTENTION:

- Steam cleaners must not be used.

- If the surface is cracked, switch off the appliance

to prevent electric shock.

- This appliance is not intended for use by young

children or infirm persons without supervision

- Young children should be supervised to ensure they

do not play with the appliance

This appliance conforms to the European Directive EC/

2002/96, Waste Electrical and Electronic Equipment

(WEEE). By making sure that this appliance is disposed

of in a suitable manner, the user is helping to prevent

potential damage to the environment or to public health.

The

symbol on the product or on the accompanying

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to a

suitable electric and electronic appliance recycling col-

lection point.

Follow local guidelines when disposing of waste. For more

information on the treatment, re-use and recycling of this

product, please contact your local authority, domestic

waste collection service or the shop where the appliance

was purchased.

INSTALLATION INSTRUCTIONS

These instructions address specialised installers and

serve as a guide for installation, adjustment and mainte-

nance in conformity with the laws and regulations in force.

If a built-in oven or any other appliance that generates

heat must be fitted directly under the glass-ceramic

cooktop, THIS APPLIANCE (oven) AND THE GLASS-

CERAMIC COOKTOP MUST BE SUITABLY INSULATED

in such a way that the heat generated by the oven,

measured on the bottom right of the cooktop, does not

exceed 60°C. Failure to respect this precaution may de-

termine improper functioning of the TOUCHCONTROL

system.

POSITIONING (Fig.1)

The domestic appliance is designed to be built into a

worktop as illustrated in the specific figure. Apply seal-

ant around the entire perimeter (cut-out dimensions

Fig.1B). Fix the domestic appliance on the worktop by

means of the 4 brackets provided, taking the thickness

of the worktop into account (Fig.1A). If the lower part of

the appliance, after installation, is accessible via the lower

part of the cabinet then it is necessary to mount a sepa-

rator panel respecting the distances indicated (Fig.1C).

If the appliance is installed with an oven underneath then

the separator is not necessary.

ELECTRICAL CONNECTIONS

Before making the electrical connections, check that:

- the ground cable is 2 cm longer than the other ca-

bles;

- the system ratings meet the ratings indicated on the

identification plate fixed on the lower part of the worktop;

- the system is fitted with efficient earthing compliant

to the laws and regulations in force.

Earthing is obligatory by law.

If the appliance is not fitted with a cable, use type:

"H05V2V2-F" for a power level of up to 6400 Watts. The

cross-section of the cable should be at least 2.5 mm², or

4 mm² for greater power levels.

The cable should never reach a temperature which is

50°C above the temperature of the room in which it is

installed.

The appliance is designed for permanent connection to

the electricity supply and should therefore be fitted with

an omnipolar switch which has a minimum opening of 3

mm between contacts. The switch should be suitable for

the charge indicated on the appliance data plate and

must conform to all current legislation (the yellow/green

earth wire must not be interrupted by the switch).

The omnipolar switch must be easy to reach once the

installation process has been completed.

USE AND MAINTENANCE

MAINTENANCE

Remove any residues of food and drops of grease from

the cooking surface using the special scraper supplied

on request (Fig.3)

Clean the heated area as thoroughly as possible using

SIDOL, STAHLFIX or similar products and a cloth/pa-

per, then rinse with water and dry with a clean cloth.

Using the special scraper (optional) immediately remove

any fragments of aluminium and plastic material that have

unintentionally melted on the heated cooking area or

residues of sugar or food with a high sugar content

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Etna T 201 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Etna T 201 Manual

Product: