557785
20
Zoom out
Zoom in
Previous page
1/32
Next page
452511
20
Failure Possible cause Remedy
FAILURE 7
Water is poorly pumped
out or not at all (machine
reports failure - the LEDs
periodically ash seven
times).
Water outlet is clogged Check if:
• the lter is clean,
• outlet pipe is not jammed,
• the drain is clogged,
• outlet pipe is positioned higher
than 1m.
Push START again
Laundry is not properly
spun.
No failure is reported.
The machine switched on the
UKS* function. Because of bad
laundry balance, the machine has
automatically reduced spin RPM.
The machine operates normally.
Wash large and small pieces of
laundry together.
Greasy wads appear on
the laundry.
Too little detergent (laundry was
very greasy).
Wash the laundry again.
Add more detergent for such soiled
laundry, or use liquid detergent.
Laundry is stained after
washing.
You used liquid detergent or
detergent for colored laundry
which does not contain whitener.
Use the detergent containing
whitener.
White powdery residues
on the laundry.
It is not the consequence of bad
rinsing, but because of neo-
phosphate detergents containing
non soluble components
(zeolites) for water softening.
Such substances may be
deposited upon the laundry.
Immediately rinse the laundry once
again.
Use liquid detergents which do
not contain zeolites.
Try removing the residues with
the brush.
Detergent residues in the
dispenser.
Low water ow pressure.
Some detergents may stick to the
dispenser rather hard if it is wet.
Clean the inlet pipe lter net.
In case of low water pressure
increase water level.
• Wipe the dispenser prior loading
detergent.
Softener is not completely
rinsed, or water is left in
the dispenser dish.
Sucking cover is not correctly
positioned or is clogged.
Clean the dispenser and rmly x
the cover to its place.
Unpleasant smell in the
washing machine drum.
Remains of fabrics, washing
agent and softener in the lter.
Development of germs
Check whether the lter is clean.
Run the auto-clean program
(see chapter: selecting additional
functions)
Washing time is longer
than usual.
Time indicated on the
display is corrected during
the washing cycle.
Low temperature of inlet water.
Due to unevenly distributed
load, the machine has activated
the UKS*.
Low mains voltage.
There has been a failure in the
power supply.
Washing program time may be up
to 60% longer; however, this does
not imply a fault in the machine.
Washing time is extended by the
power supply down-time.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna EWM246D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna EWM246D in the language / languages: English as an attachment in your email.

The manual is 3,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Etna EWM246D

Etna EWM246D User Manual - German - 32 pages

Etna EWM246D User Manual - Dutch - 32 pages

Etna EWM246D User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info