557784
18
Zoom out
Zoom in
Previous page
1/32
Next page
452515
• Insert the lter back as shown on the picture, and tighten by
turning it in clockwise direction. To ensure good sealing the
gasket surface (A) must be dirt free.
The washing machine automatically monitors the execution of particular functions during the
operation, and reports any detected failures.
In such cases signal LED’s start ashing in certain sequence.
The ashing sequence changes in accordance with the nature of the detected failure.
In some cases you may attempt removing certain failures yourself, so count the number of ashes,
repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the program, except for
heater failure, where the machine completes the washing program without heating water.
Failures:
2 - Two ashes: door is not correctly closed
3 - Three ashes: inappropriate water intake
7 - Seven ashes: inappropriate water outlet.
In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).
1 - One ash: temperature sensor failure
4 - Four ashes: spinning sensor failure
5 - Five ashes: motor failure
6 - Six ashes: Heater failure
In these cases, turn off the machine, then turn it back on and repeat the program. If the failure
reoccurs, contact your nearest authorized service center. The LEDs will continue to ash until the
machine is turned off.
Interferences from the ambient (for example electrical wiring) could induce signalization of different
faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning
stroke, power supply circuit faults, natural disasters).
18
Failures
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna EWM245K at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna EWM245K in the language / languages: English as an attachment in your email.

The manual is 3,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Etna EWM245K

Etna EWM245K User Manual - German - 32 pages

Etna EWM245K User Manual - Dutch - 32 pages

Etna EWM245K User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info