558297
22
Zoom out
Zoom in
Previous page
1/28
Next page
The food is too warm.
Interior lighting does
not work.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
Temperature is not
properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing the
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
W
ater drain hole is blocked.
Please look in the “initial Start Up”
section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the “installation
location” section.
Please look in the “changing the
Light Bulb “section.
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the warmed
door seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the w
ay.
The compressor starts after a
period of time.
See the “cleaning and care”
section.
Warning! If the LED light bulb is
damaged, only a qualified electrician
of competent person must carry out
it!
Changing the light bulb
Heavy build-up of
frost, possibly also on
the door seal.
9
Changing the LED light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning. it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
Before changing the light bulb, switch
off the appliance and unplug it, or pull
the fuse or the circuit breaker.
LED light bulb data: 220-240 V.
To switch off the appliance, set the
temperature regulator to position “0”.
Unplug the mains plug.
Press the bulb in the center with finger.
Take out the lampshade with “1” type
screwdriver, change the bulb, and then
replace the lampshade.
Put the refrigerator back into oper
ation.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna EKV1802 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna EKV1802 in the language / languages: English, Dutch as an attachment in your email.

The manual is 8,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info