Manual Etna EEO131VA (page 54 of 57) (English, German, Dutch, French)

482932

Zoom out

Zoom in

1/57

Instructions for Use

Maintenance and Cleaning

Automatic Defrosting of the

Refrigerator

The refrigerator requires no defrosting, since the

ice at the rear wall melts automatically. Ice,

formed at the rear end during the operation of the

compressor, melts when the compressor is off,

and water drops slide downwards through the

hole in the rear wall o the condenser collecting

receptacle, placed at the bottom of the appliance.

Manual Defrosting of the Frezing

Compartment

When the frost and ice layer in the frezing

compartment is 3-5 mm thick, you should clean

the freezer.

• Turn the thermostat knob to STOP (0) position,

and disconnect the power supply. Empty the

compartment and take care that the packages

remain frozen.

• Melted water, collected at the bottom of the

appliance, should be mopped with an absorbing

cloth.

• Avoid using defrosting sprays, as they may

cause damage to the plastic parts and may be

hazardous to health.

Cleaning the Appliance

Disconnect the power supply before cleaning

the appliance.

Do not use coarse or aggressive cleaning agents

as you can damage the surface.

Be careful to remove any cleanser agent

remaining after cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth

and an alcohol based cleaning agent (for

example glass cleaners). You may also use

alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially

aggressive cleaners, such as the stainless steel

cleaners, is not appropriate for the cleaning of

plastic and coated parts.

• Remove the detachable accesories in the

interior of the appliance and clean it with water

and liquid detergent. Plastic parts cannot be

washed in washing machine.

• Wash the interior of the appliance with

lukewarm water, in which you added one or two

spoonfuls of vinegar.

• The air openings in the bottom rail should be

cleaned or vacuumed periodically.

Cleaning of the condenser

Dust from the condenser should be

vacuumed in the following manner:

− push the finger through the opening in the

bottom rail and release the fastener;

− pull the rail towards you and remove it;

− remove the bottom board of the kitchen cabinet

− pull the condenser dish out;

− use the vacuum cleaner to clean the dust from

the condenser;

− replace the condenser dish and the bottom rail

in the opposite order.

After cleaning, connect the appliance to power

supply and reload the packages.

Periodical cleaning of the condenser

In order to optimize the operation of the

appliance and save energy, it is

recommended to clean periodically the dust

from the condenser at the back of the

appliance.

Disconnect the appliance from the mains prior the

commencement of cleaning!

• Empty the contents of the appliance.

• Remove the supporting panel from the bottom

of the kitchen cabinet.

• Remove the screws fixing the appliance to the

kitchen worktop.

• Pull the appliance out and expose the

condenser at the back of the appliance.

• Unscrew the screws from the condenser bonnet

and remove the bonnet.

• Clean the dust and dirt from the condenser.

After cleaning return the appliance to its place,

plug in the mains power cord and fill with food.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Etna EEO131VA in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Etna EEO131VA Manual

Product: