557539
43
Zoom out
Zoom in
Previous page
1/48
Next page
43
444151
Problem/error Cause What to do ...?
The dryer does
not work.
•No voltage in the power outlet. •Check if the power cord plug is
correctly inserted into the power
outlet.
•Check the fuse.
There is voltage
in the outlet, but
the drum does
not spin and the
dryer does not
work.
•Program was not started
in accordance with the
instructions.
•The door is not properly
closed.
•Condensate tank is full.
•Delayed start function has
been selected.
•Reread the instructions for use again.
•Push the door towards the appliance.
•Empty the condensate tank (see
section Cleaning and Maintenance).
•Wait until the time indicated on the
display elapses.
Laundry is not
dried, or drying
temperature is
longer than 4h.
•Filters are not clean. The room
is not sufficiently ventilated.
•Inappropriate temperature in
the room.
•Laundry was not sufficiently
wrung or spun.
•Amount of laundry dried in
the appliance is too large or
insufficient.
•Clean the filters.
•Check whether water condenser is
cleaned.
•Install the dryer in an appropriate
room (see section Installation ...).
•Check if the temperature in the room
where the dryer is installed is too
high (over 25°C) or too low (below
10°C).
•Laundry inserted into the dryer was
not sufficiently wrung or spun, or an
inappropriate drying program was
selected.
•Use an appropriate program or use
the timed program. Increase the
final level of dryness for the selected
program (intensive drying function).
Poor
condensation
•Inadequate location of the
dryer.
•Check whether the ambient
temperature of the room is not too
high.
•Check whether the condenser is clean.
Unevenly dried
laundry.
•The amount of laundry dried at
a time is too large.
•Drying the pieces of different
thicknesses.
•Drying the different types of
laundry.
•Make sure the laundry is sorted by
type and size of items given the
selected program (see section Drying
– Preparing the Laundry and the
Program Table).
Error in the drum
lighting.
•There is no lighting when the
dryer door is opened.
•Disconnect the dryer from the power
mains and call an authorized service
unit.
On display: F3 •Full condensate tank.
•If the condensate tank is
empty, there is a pump failure.
•Empty the condensate tank (see
section Cleaning and Maintenance).
•Disconnect the appliance and call the
nearest service unit.
On display:F4 •Clogged filters.
•If the filters are clean, there
may be a compressor failure.
•Clean the filters.
•Disconnect the appliance and call the
nearest service unit.
On display:"LO" •Steam generator tank is empty •Add distilled water.
Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call the
nearest authorized service (call center).
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna EDM117C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna EDM117C in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Etna EDM117C

Etna EDM117C User Manual - German - 48 pages

Etna EDM117C User Manual - Dutch - 48 pages

Etna EDM117C User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info