75567

Etna 1981 VW Manual

9
Zoom out
Zoom in
Previous page
1/21
Next page
GEBRUIK VAN DE GASGRILL
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. B
RL F
P
G
Fig. 11
M
H
I
Fig. 12
R
G
140
210
170
250
Fig. A
S
TAB. C
GERECHT TEMP. °C GERECHT TEMP. °C
VLEES GEBAK
VARKENSGEBRAAD 185-210 FRUITTAART 220
RUNDGEBRAAD 250 CAKE 190
OSSEGEBRAAD 240 BRIOCHES 175
KALFSGEBRAAD 220 BISCUITDEEG 235
LAMSGEBRAAD 220 KOEKJES 190
ROAST-BEEF 230
ZOET BLADERDEEGGEBAK 200
HAAS 235 ROZIJNENGEBAK 200
KONIJN 220 STRUDEL 180
KALKOEN 235 LANGE VINGERS 290
GANS 225 APPELFLAPPEN 200
EEND 235
PUDDING VAN LANGE VINGERS 200
KIP 200-225 TOAST 250
VIS 200-225 BROOD 230
10 35
BRANDER MET VEILIGHEIDSTHERMOKOPPEL
Bij branders die voorzien zijn van een veiligheidsthermokoppel,
moet u de knop na inschakeling van de brander nog ongeveer 10
seconden vast blijven houden (fig.9), zodat de veiligheidsklep in
werking treedt. Als de vlam dooft nadat u de knop heeft losgelaten,
bovenbeschreven handelingen herhalen.
Gebruik van de oven
De oven voor gebruik voorverwarmen op de gewenste temperatuur.
Nadat de gewenste temperatuur bereikt is, de gerechten in de
oven zetten en de baktemperatuur controleren. Zet de oven 5
minuten voor het verstrijken van de bereidingstijd uit om de
restwarmte te gebruiken. Hieronder volgt een lijst met indicatieve
bereidingstijden van verschillende gerechten (tabel C).
LET OP: de inschakelknop niet langer dan 15 seconden
vasthouden.
Als de brander van de oven niet aangaat, de ovendeur tenminste
1 minuut open laten staan voordat u de knop opnieuw indrukt.
Elektrische inschakeling
Om de grillbrander in te schakelen, de knop indrukken en tegen
de klok in op de stand (Fig. 7) zetten; tegelijkertijd op de
elektrische inschakelknop op het paneel (aangegeven met het
symbool ) drukken.
Als er geen elektrische stroom is, kan de brander ook worden
aangestoken met een lucifer (fig. 10).
BRANDER MET VEILIGHEIDSTHERMOKOPPEL
Bij branders die voorzien zijn van een veiligheidsthermokoppel
moet u de knop na inschakeling van de brander nog ongeveer 10
seconden vast blijven houden (fig.9), zodat de veiligheidsklep in
werking treedt. Als de vlam dooft nadat u de knop heeft losgelaten,
bovenbeschreven handelingen herhalen.
- Plaats de knoppenbescherming S en laat de deur halfopen
(zie fig. A).
LET OP :
De grill moet worden gebruikt met half geopende deur .
Plaats de knoppenbescherming S en laat de deur halfopen
(zie fig. A).
Braadspit - ( Mod. 1920 ).
Voor het gebruik van het draaispit, als volgt te werk gaan:
- Steek de kip of het te roosteren gedeelte op het spit L en zet
het stevig en goed uitgebalanceerd vast tussen de twee vorkjes
F, om een onnodige overbelasting van de reductor R (fig. 11)
te vermijden.
- Plaats het spit op support G, na het andere uiteinde ervan in
het gat P van het motortje R (fig. 11) te hebben gestoken.
Plaats support G volledig in de oven, om de spies I in het gat
H van motor M van het braadspit te laten vallen (Fig. 12).
- Zet de druippan met een beetje water erin onder het spit.
- Draai de knop op symbool (fig. B)
- Om het spit te verwijderen moet u andersom te werk gaan en
knop A en een handschoen van isolerende wol gebruiken
(Fig 13).
GAS CONNECTION
Fig. 2
1/2
2
1
3
4
5
L
N
A
Applance type Supply single-phase 230 V~
Type of cable section
All gas + elett. oven Rubber H05 RR-F
Applance type Supply single-phase 230 V~
Type of cable section
All gas + gas oven Rubber H05 RR-F
The appliance must be connected to the gas piping in a workmanlike
way and in conformity with the regulations in force which lay down
the installation of a safety valve at the end of the piping.
For butane and propane a pressure reducer conforming to the
standards in force may perform this task.
The seal gaskets must be in accordance with rules.
Once the gas appliance has been connected, check the connection
seal by means of soapy water.
The end of the attachment is threaded.
The possible connections are:
We recommend to check wether the appliance has been foreseen
for the kind of gas distributed.
- by rigid pipe in iron or copper
- by flexible tube in stainless steel with continuing wall, with
mechanical connection in accordance with rules. The tube must
be directly connected to the manifold elbow (see Fig.2).
- by the insertion of a rubber tube in accordance with rules.
This tube must be connected directly on the push-on connector,
concerning the gas used, and it must be blocked with a band.
In the last case, check the tube's printed date of expiry and
replace it before this date.
STOP
INLET
Certain types of cookers can be set for sypply both on the right
and
lefthand side. In this case it is sufficient to reverse the position
of the cad nipple reducer. At the end make sure than there is no
leakage of gas.
ELECTRICAL CONNECTION
REPLACEMENT OF THE CABLE
In case the cable is damaged, replace it in accordance with the
following instructions:
- open the box of the supply board as described on the picture
below;
- unscrew screw A fixing the cable;
- replace the cable with one of the same lenght and in accordance
with the features described on the table; switch the appliance
off, and close the gas tap
- the green-yellow earth wire must be connected to the terminal
  and it must be about 10 mm longer thean the live wires;
- the blue neutral wire must be connected to the terminal marked
with letter N;
- the live wire must be connected to the terminal marked with letter
L.
This appliance must be earthed by law. Before connecting
the
appliance to the electrical supply, check that the earth
system in your house is working correctly.
Check that unit voltage and power, marked on the rating plate
applied on the appliance, are correct for the supply. It is necessary
that the feeding network is protected by a powerful switch able to
disconnect completely the network with a contacts separation of
at least 3 mm. Be sure that the earth wire green/yellow is not
interrupted by the switch.
Important: The wires in the mains lead are so coloured:
- green/yellow = earth " "
- blue = neutral N
- brown = live L
The wire coloured green/yellow must be connected to the terminal
in the plug which is marked with letter 'E' or by the earth symbol
or coloured green or green/yellow. The wire coloured blue must
be connected to the terminal which is marked with letter 'N' or
coloured black. The wire coloured brown must be connected to
the terminal which is marked with letter 'L' or coloured red. The
supply cable must not come into contact with any component the
temperature of which exceeds the ambient temperature by 50°C.
If a plug is used for connection, the plug to be connected to the
supply cable and the socket to which it is connected must be of
Connection of the appliance to the power mains should be done
by a licensed electrician familiar with local safety regulations.
3 x 1,5 mm
2
the same type (conforming to the standards). Easy access to the
plug or the switch is ensured once the appliance is installed. Ensure
that there is sufficient cable allowed for any subsequent removal
of the unit. If the plug is non-rewireable, pay attention to the
following points: the plug must never be cut by the supply cord.
There is shock hazard when this plug is inserted in a socket-outlet
elsewhere in the house. Never use the plug without the fuse cover
fitted. Referring to the pertinent spare parts, apply to the appliance's
supplier.
3 x 0,75 mm
2
L
N
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna 1981 VW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna 1981 VW in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info