Manual ESX HXE2000.1D (page 10 of 32) (English, German, French, Italian, Spanish)

700202

Zoom out

Zoom in

1/32

AUDIO SIGNAL CABLES

WheninstallingtheaudiocablesbetweentheRCAoutputsoftheheadunitandtheRCAinputsoftheamplier,

the audio and power supply cables should, if possible, not be routed along the same side of the vehicle. We

recommend a separated installation, e.g. routing the power cable through the cable channel on the left side

and the audio cables through the cable channel of the vehicle on the right side or vice versa. This prevents

interferences due to crosstalk into the audio signal.

SIGNAL OUTPUTS TO CONNECT ADDITIONAL AMPLIFIERS

The input signal on the LINE INPUT jacks (Fig. 1,2) will be routed in stereo to the output jacks LINE OUTPUT

(Fig.1,1).ThustheLINEOUTPUTjackallowstheconnectionofaadditionalamplier.

INPUT SENSITIVITY

OPERATING ELEMENTS

TurntheINPUTLEVEL(Fig.1,3)controlleroftheampliertotheMINposition.Thenturnthevolumecontroller

of the headunit to 80 - 90% of its full setting. Now turn INPUT LEVEL clockwise until you hear some distortion.

Then turn back the INPUT LEVEL slightly until you hear a cleaner sound.

VARIABLE SUBSONIC FILTER

WiththeSUBSONICcontroller(Fig.1,5)youcanadjustthelowercross-overfrequency,toltertheverylow

frequencies to relieve the subwoofer or to generate a bandpass signal. If you don’t want to use this function,

turn the controller (Fig. 1,5) to the very left to the 10 Hz position.

NOTE: The adjusted value of the SUB SONIC (Fig. 1,5) should not be higher than the adjusted value of the

LOW PASS controller (Fig. 1,6). Otherwise no sound will be hearable.

PROTECTION CIRCUIT

ThePOWER/PROTECTION-LED(Fig.1,9)litsup,iftheamplierisinoperation.

ThePOWER/PROTECTION-LED(Fig.1,9)litsup,whentheamplierisoverheated,orashortcircuitoccurs

resp. a too low impedance load is connected to the speaker outputs. If this events, the internal built-in pro-

tectioncircuitshutsdowntheamplierautomatically.Theampliershouldworkagainproperlyafteryouhave

solved the problems.

VARIABLE LOW PASS FILTER

Set the desired cross-over frequency by using the controller LOW PASS (Fig. 1,6). Thus to that only the fre-

quenciesbelowthechosencross-overfrequencywillbeampliedandthesubwooferplaysmoreprecisedand

efcient.

BASS LEVEL REMOTE CONTROLLER

With the included bass level cable remote controller you are able to adjust the bass level e.g. out of the driver’s

seat.

VARIABLE BASS BOOST

With the bass boost controller (Fig.1,7) you are able to adjust the bass level from 0 - 12 dB.

Attention: Use the BASS BOOST wisely!

VARIABLE PHASE SHIFT

The PHASE SHIFT controller (Fig. 1,4) allows to set the phase between 0°and 180° to match the run time of

the output signal with the vehicle’s interior acoustic.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of ESX HXE2000.1D in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

ESX HXE2000.1D Manual

Product: